Charging The Battery; Cleaning And Maintenance; Technical Data - Renkforce 2436001 Bedienungsanleitung

Charging the battery

Make sure the battery is charged via the USB power supply with an output voltage
of 5 V DC and a minimum current carrying capacity of 500 mA. Non-compliance with
these requirements may damage the USB power supply or the laser pointer.
Fully charge the battery before using the device for the first time.
Charge the battery on a regular basis, even when you are not using the device (at
least once every two months). Failure to charge the battery regularly may cause the
battery to overdischarge, which can cause permanent damage.
• Unscrew the USB port cover (5) from the laser pointer.
• Connect the USB plug of the laser pointer's to the USB port of the power supply that serves
to charge the battery.
• Battery charging starts when the USB plug is connected and the USB power supply is turned
on.
• The LED indicator (3) is responsible for the charging process.
• Once the battery is fully charged, the LED indicator (3) goes off.
• When you are done with charging, screw the USB port cover (5) back onto the laser pointer.
Operation
• Press the power button (4) to switch on the laser pointer.
• The laser beam is emitted through the laser outlet opening (1) for as long as the
power button (4) is pressed.
• The laser pattern effect can be changed by turning the effect adapter (2) clockwise.
• To project a laser point, screw the effect adapter (2) from the laser pointer by turning it
counter-clockwise.

Cleaning and maintenance

The device must not be immersed in water for cleaning.
Never use aggressive detergents, rubbing alcohol, organic solvents or other
chemical solutions, as these may damage the device or prevent it from functioning
properly.
You can clean the device with a clean, soft, dry or slightly damp cloth. The device requires no
other maintenance.
Disposal
Electronic devices are recyclable waste and must not be placed in household waste.
At the end of its service life, dispose of the product in accordance with applicable
regulatory guidelines.
The built-in rechargeable battery cannot can be removed and must be disposed of
together with the product.

Technical data

Charging voltage ..................................5 V/DC
Charging current consumption .............max. 500 mA
Battery ..................................................Li-ion battery 3.7 V/220 mAh
Battery life . ............................................approx. 5 h
Laser output power . ..............................<1 mW
Laser class ...........................................2
Laser wavelength .................................630-680 nm
Laser range ..........................................max. 15 m
Ingress protection . ................................IPX4
Weight ..................................................75 g
Dimensions . ..........................................150 x 20 mm
Operating conditions . ............................-10 to +40 °C/30-80% relative humidity
Storage conditions . ...............................-10 to +40 °C/25-85% relative humidity
This is a publication by Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240 Hirschau (www.conrad.com).
All rights including translation reserved. Reproduction by any method (e.g. photocopying, microfilming or capturing in
electronic data processing systems) requires prior written approval from the publisher. Reprinting, also in part, is
prohibited. This publication reflects the technical status at the time of printing.
Copyright 2021 by Conrad Electronic SE. 2436001_v1_1121_02_VTP_m_en