Niko 550-20220 Bedienungsanleitung Seite 16

Follow the steps below to install the mini detector:
1 Make an opening with a diameter of 3 cm in the ceiling.
2 Connect the mini detector to the two-wire bus cable using a standard connector (not included). To do this, use the two
wires that emerge from the top of the detector. These are 50 cm long, have a diameter of 0.5 mm² and the ends are
fitted with end terminals with a diameter of 1 mm and a length of 8.8 mm.
3 Bend the spring clamps upwards and insert the mini detector carefully into the opening in the ceiling. The spring clips
make it easy to fix the device.
Do not install the mini detector in the vicinity of heat sources, air currents from ventilation systems or moving
objects. These may set off the mini detector.
Programming
You can determine and modify the settings of the mini detector in the Niko Home Control programming software. The
following three settings can be modified:
• the light level
• the sensitivity to movement ("low", "medium low", "medium high", "high")
• the switch-off delay.
• the operating mode (presence or absence detector)
• operating mode of the light sensor (dark and light or dark only)
In the software you can determine which action should be carried out upon reaching a particular light intensity and/or with
movement.
Once in operation, the user can adjust the settings of the mini detector in the programming software.
Addressing
Once you have installed the mini detector in the ceiling and followed the steps "Project", "Creation" and "Fill Cabinet" in the
programming software, you end up in the step "Addressing". Here you will be prompted to address all inputs one by one.
As soon as you start the addressing, the green light on the mini detector will start to flash. The mini detector will only pass on
an address when detecting a significant difference in light intensity. This kind of difference in light intensity is made by shining
a torch onto the mini detector (when there is little light in the area) or by covering it (when there is lots of light in the area). As
soon as the address has been sent correctly, the green LED on the detector will start to shine continuously.
Addressing is also possible by entering the unique MAC address manually in the programming software. You can
find this MAC address on the mini detector.
16
Mini detector for Niko Home Control