Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Instructions for mounting and use:
Dear customer,
Congratulations for purchasing our bathroom furniture, which will provide you with long-lasting pleasure, if you will follow our
instructions for cleaning and maintenance:
Keep the packaging material and small parts out of the reach of children.
Please polish the furniture and the mirror with a moist cloth, only use mild detergents.
Please mind the instructions of microfibre cloths. Unsuitable microfibre cloths can do severe damage to the fronts.
No alcoholic, scratching or aggressive cleansing agents (glass detergents).
Please wipe the furniture always with a dry cloth to avoid any damages to the material (swelling) or of the mirror surface (blind
stains) because of remaining water.
Do not use steam cleaner. The use of steam cleaners leads to swelling of the wood and ruins the furniture.
All fittings of the basin plate in contact with other cupboards and walls or to the base itself have to be sealed with silicone or other
appropriate sealing materials.
Protect your furniture – if in contact to shower or tub – by a shower severance.
Please note that we cannot accept any complaints regarding damages of extraordinary effects by water or humidity. Our bathroom
furniture is meant for use at regular bathrooms conditions, including shorttime air humidity of 90 % (no sauna).
The included hooks and dowels are only suitable for walls of masonry, bricks MZ20 hole bricks HLZ20 or concrete B25.
ATTENTION ! Before mounting please check the product to see if any damage has been caused during transportation. Please
keep the packaging in case of complaint. Please note that we cannot accept any complaints regarding damage after the product
has been mounted.
Information for furniture with electrical connection and lighting:The electrical device must be connected by a qualified
electrician in compliance with IEC 60364-7-701!
To increase security an RCCB (Rated leakage current - 30mA - EN 61008) has to be provided on site/by customer.
Avoid unattended operation of device.
Disconect control gear during thunderstorms or when not used for a longer period. By this means damages caused by lightning or voltage surges can
be avoided.
A outer cable must be replaced only by a specialist.
The trafo-box cannot be repaired and must be replaced.
When changing bulbs, make sure that the maximum wattage (W) and the voltage (V) of the replacementbulb conform to the transformer or lamp.
Disconnect the power supply before changing bulbs. In case of
a fixed installation the electrical connection has to be equipped
with a seperating appliance (f.ex. switch).
Protected isolation, protection class I, appliance
with protected connection (yellw/green).
Protected isolation, protection class II,
appliance without protected connection.
Protected isolation against low voltage (≤ 50V), protection
III
class III, appliance without protected connection.
For direct installation on heavy or normal infallable
F
materials.
Suitable for installation in furniture, but not on normal
M
M
inflammable surfaces.
The average life time of our LEDs is 15,000 hours. The
optical power is around 70% of the exit optical power after
the mentioned life time.
Avoid a longer direct visual contact with the LED light
source since otherwise damage to the eye could arise.
Removal of light sources and separate control gear.
You can find the document here: https://www.fackelmann.com/downloads/Oekodesign_Anforderungen_01_2021.pdf
Electronic products are not allowed to disposed to houshold rubbish. Supply these products to the suitable recycling
companies. Please inform you by your commune or a disposal company about the suitable recycling options.
ATTENTION HIGH RISK OF BREAKING:
STOP
STOP
If the article is to be shipped, please pack it in exactly the same fashion as how you recived it. Use the original packing with
filling and paddding material. As otherwise we would have to charge You for any damage occurring transit!
Protect lamp from moisture or
wetness during.
Minimum distance to the illuminated
surface f.ex. 10 cm.
This lamp is not suitable for cool beam lamps.
Cool
Beam
Light source is not changeable.
Light souce is changeable by the end-customer.
Light source is changeable by experts.
LED
Separate control gear is not changeable.
Separate control gear is changeable by
the end-customer.
Separate control gear is changeable by experts.
GB
Werbung
