Operating and Installation Instructions
Dieses Produkt darf nur von Personen installiert werden, die sich mit der Reparatur und Modifikation von Fahrzeug-Kraftstoff-
This product is to be installed only by persons knowledgeable in the repair and modification of vehicle fuel systems
systemen und allgemeinen Änderungen an Fahrzeugsystemen auskennen. Die Installation dieses Produkts sollte nur von einem
This product is to be installed only by persons knowledgeable in the repair and modification of vehicle fuel systems
and general vehicle systems modification. Only a qualified technician or mechanic who is aware of applicable
qualifizierten Techniker oder Mechaniker durchgeführt werden, der mit den geltenden Sicherheitsverfahren vertraut ist.
and general vehicle systems modification. Only a qualified technician or mechanic who is aware of applicable
BENZIN UND ANDERE KRAFTSTOFFE SIND BRENNBAR UND KÖNNEN EXPLOSIV SEIN!
GASOLINE AND OTHER FUELS ARE FLAMMABLE AND CAN BE EXPLOSIVE!
Führen Sie die Installation nur an einem gut belüfteten Ort durch, um die Bildung von Kraftstoffdämpfen zu minimieren. Während
GASOLINE AND OTHER FUELS ARE FLAMMABLE AND CAN BE EXPLOSIVE!
Perform the installation in a well ventilated location only to minimize the build up of fuel vapors. NO open flames,
der Installation dürfen KEINE offenen Flammen, Rauchen oder andere Zündquellen vorhanden sein, um Feuer oder Explosionen
Perform the installation in a well ventilated location only to minimize the build up of fuel vapors. NO open flames,
smoking or other sources of ignition are to be present during installation, to prevent fire or explosion that can cause
zu verhindern, die zu schwere Verletzungen oder Tod verursachen können. Schleifen, Schneiden und Bohren müssen mit Sorg-
smoking or other sources of ignition are to be present during installation, to prevent fire or explosion that can cause
falt durchgeführt werden, um eine Entzündung zu verhindern. Es wird empfohlen, den gesamten Kraftstoff abzulassen und zu
serious injury or death. Grinding, cutting, and drilling must be performed with care to prevent ignition. Draining and
entfernen und die Dämpfe im Fahrzeug und im Kraftstoffsystem zu entlüften, wenn solche Arbeiten durchgeführt werden. Wäh-
serious injury or death. Grinding, cutting, and drilling must be performed with care to prevent ignition. Draining and
removal of all fuel and ventilation of vapors in vehicle and fuel system is recommended when performing such
rend der Installation ist stets ein geeigneter Augen- und Personenschutz erforderlich
removal of all fuel and ventilation of vapors in vehicle and fuel system is recommended when performing such
procedures. Proper eye and personal protection is required at all times during installation.
procedures. Proper eye and personal protection is required at all times during installation.
Das Kraftstoffsystem des Fahrzeugs kann unter Druck stehen! Lösen Sie keine Kraftstoffverbindungen, bevor der Druck im
The Vehicle's fuel system may be under pressure! Do not loosen any fuel connections until relieving all fuel system
Kraftstoffsystem nicht vollständig abgebaut ist. Lesen Sie in einem entsprechenden Wartungshandbuch nach, wie Sie den Druck
The Vehicle's fuel system may be under pressure! Do not loosen any fuel connections until relieving all fuel system
pressure. Consult an applicable service manual for instructions to relieve fuel system pressure safely.
im Kraftstoffsystem sicher abbauen können. Dieses Produkt ist nur für den Einsatz im Rennsport, im Gelände oder auf See vor-
pressure. Consult an applicable service manual for instructions to relieve fuel system pressure safely.
This product is intended for racing, off-road, or marine use only. This fuel system component is capable of altering
gesehen.Diese Kraftstoffsystemkomponente kann die Motorabstimmung verändern und ist daher nicht für den Verkauf oder die
This product is intended for racing, off-road, or marine use only. This fuel system component may not be legal for
engine tuning and therefore not legal for sale or use on emission controlled motor vehicles.
sale or use on emission controlled motor vehicles; consult local, state and national laws.
Product Contents:
Produktinhalte:
Product Contents:
Check the diagram and list of components
Überprüfen Sie das Diagramm und die Liste der Kom-
Check the diagram and list of components
(right) to ensure that no components are
ponenten(rechts), um sicherzustellen, dass keine Teile
(right) to ensure that no components are
missing from box. Contact your Fuelab
in der Packung fehlen. Wenden Sie sich für Ersatz
missing from box. Contact your Fuelab
distributor immediately for replacement.
sofort an Ihren FueLab-Händler
distributor immediately for replacement.
52902-c Merkmale- und Leistungsdaten:
51501 Features and Performance Ratings:
52902-c Features and Performance Ratings:
Fittinggrößen
Inlet Port Sizes
Fitting Sizes
Seat Size
Sitzgröße
Seat Size
Regulation Slope
Betriebsspanne
Operating Voltage
Maximum Flow
Maximale
Capacity
(570 LPH at 1.75 Bar)
Maximum Flow
Durchflusskapazität
Pressure
Capacity
Druck-
Adjustment Range
Pressure
einstellbereich
Adjustment Range
WARNING!
Exceeding maximum flow capacity may result in an over-pressure operating condition.
WARNUNG!
Das Überschreiten der maximalen Durchflusskapazität kann zu einem
WARNING!
Exceeding maximum flow capacity may result in an over-pressure operating condition.
Before Installation, Plan Entire Fuel System:
These instructions are limited to general topics of regulator component installation and may not include specific
Before Installation, Plan Entire Fuel System:
Planen Sie vor der Installation das gesamte Kraftstoffsystem:
information pertaining to your application. These instructions are written assuming the use of an electric fuel pump
Diese Anleitung beschränkt sich auf allgemeine Themen zur Installation von Reglerkomponenten und enthält möglicherweise keine spe-
These instructions are limited to general topics of regulator component installation and may not include specific
capable of at least 100 PSIG outlet pressure and limited to the specified Maximum Flow Capacity (above). This
zifischen Informationen, die für Ihre Anwendung relevant sind. In dieser Anleitung wird von der Verwendung einer elektronischen Fuelab
information pertaining to your application. These instructions are written assuming the use of a Fuelab Prodigy
Prodigy-Kraftstoffpumpe ausgegangen. Dieser Regler ist NUR mit Prodigy-Kraftstoffpumpen kompatibel (Prodigy-Modelle 41401-c,
regulator has an internal spring that can be changed for other pressure ranges, including "T" range, for 10-25 PSID
Electronic Fuel Pump. This regulator is ONLY compatible with Prodigy Fuel Pumps (Prodigy Models 41401-c,
41402-c, 41403-c, 42401-c, 42402-c, 91901 und 92902 nicht kompatibel mit Prodigy-Modellen 41404-c, 40401-c, 40402-c und 90902).
if required by the specific application. Lower, carbureted pressure ranges are recommended for a different model of
41402-c, 41403-c, 42401-c, 42402-c, 91901 and 92902 not compatible with Prodigy Models 41404-c, 40401-c
Dieser Regler hat eine interne Feder, die für andere Druckbereiche, einschließlich des „G"-Bereichs, für 90-125 PSID ausgetauscht
regulator only. Visit our company website for specific details pertaining to example fuel systems and other solution
40402-c and 90902). This regulator has an internal spring that can be changed for other pressure ranges, including
werden kann, wenn dies für die jeweilige Anwendung erforderlich ist. Niedrigere, vergasergesteuerte Druckbereiche werden nur für ein
ideas. Additional information including advanced troubleshooting, any special alerts and FAQ's pertaining to this
"G" range, for 90-125 PSID if required by the specific application. Lower, carbureted pressure ranges are
anderes Modell des Reglers empfohlen. Besuchen Sie unsere Firmenwebsite für spezifische Details zu Beispiel-Kraftstoffsystemen und
and other products is also available.
recommended for a different model of regulator only. Visit our company website for specific details pertaining to
andere Lösungsideen. Zusätzliche Informationen, wie z.B. erweiterte Fehlersuche, spezielle Warnhinweise und FAQ's zu diesem und
example fuel systems and other solution ideas. Additional information including advanced troubleshooting, any
anderen Produkten, sind ebenfalls verfügbar.
General Regulator Performance Notes:
special alerts and FAQ's pertaining to this and other products is also available.
Allgemeine Hinweise zur Leistung des Reglers:
The notation "PSIG" means pressure in Pounds per Square Inch (PSI) relative to the prevailing atmospheric
Die Schreibweise „PSIG" bedeutet Druck in Pfund pro Quadratzoll (PSI) relativ zu den vorherrschenden atmosphärischen Bedingun-
condition or outside air. This is referred to as Gauge Pressure. The notation "PSID" means pressure in PSI relative
General Regulator Performance Notes:
gen Bedingungen oder Außenluft. Dies wird als Überdruck bezeichnet. Die Schreibweise „PSID" bedeutet Druck in PSI relativ zu einer
to another pressure source or called the Differential Pressure. The intake manifold pressure, when plumbed to the
The notation "PSIG" means pressure in Pounds per Square Inch (PSI) relative to the prevailing atmospheric
anderen Druckquelle oder wird als Differenzdruck bezeichnet. Der Ansaugkrümmerdruck, wenn er an den Regler angeschlossen ist,
regulator, changes the fuel pressure in a 1:1 ratio. When the engine idles (for example 12 Inches of Mercury or 6
condition or outside air. This is referred to as Gauge Pressure. The notation "PSID" means pressure in PSI relative
ändert den Kraftstoffdruck im Verhältnis 1:1. Wenn der Motor im Leerlauf läuft (z. B. 12 Zoll Quecksilber oder 6 PSIG Unterdruck), sinkt
PSIG of vacuum) fuel rail pressure will lower 6 PSI, when compared to the setting with the engine off. For boosted
to another pressure source or called the Differential Pressure. The intake manifold pressure, when plumbed to the
der Druck in der Kraftstoffleitung um 6 PSI im Vergleich zur Einstellung bei ausgeschaltetem Motor. Bei Anwendungen mit Ladedruck,
applications, including turbo or superchargers, fuel rail pressure increases at a 1:1 ratio. An engine at 10 PSIG of
regulator, changes the fuel pressure in a 1:1 ratio. When the engine idles (for example 12 Inches of Mercury or 6
einschließlich Turbo oder Kompressor, erhöht sich der Druck in der Kraftstoffleitung in einem Verhältnis von 1:1. Ein Motor mit 10 PSIG
boost as measured in the intake manifold, will increase the fuel pressure by 10 PSIG. The actual readings of
PSIG of vacuum) fuel rail pressure will lower 6 PSI, when compared to the setting with the engine off. For boosted
Ladedruck, gemessen im Ansaugkrümmer, erhöht den Kraftstoffdruck um 10 PSIG.
pressure in a real world application would show a lower pressure, as the engine is using fuel that would normally be
applications, including turbo or superchargers, fuel rail pressure increases at a 1:1 ratio. An engine at 10 PSIG of
returning back through the return line when the engine is off. The amount of pressure difference to expect is a
boost as measured in the intake manifold, will increase the fuel pressure by 10 PSIG.
function of how much flow the engine is using (reference Regulation Slope, above).
Bedienungs- und Installationsanleitung:
Operating and Installation Instructions
Dieses Produkt ist unter einem oder mehreren der folgenden Patente geschützt: US 7,810,470
This Product is protected under one or more of the following patents: US 7,810,470
ACHTUNG!
safety procedures should perform the installation of this product.
safety procedures should perform the installation of this product.
WARNUNG!
W
W
Verwendung an emissionskontrollierten Kraftfahrzeugen zugelassen.
-6AN Fitting männlich
-10AN Military Port
-8AN Male Fitting
Standard
Standard
Standard
3 PSI/GPM
8-18 Volts DC
2.5 GPM at 25 PSID
8-18 Volts DC
6.3 GPH bei 35 PSID
6.3 GPM at 35 PSID
(1440 LPH bei 2.4 Bar)
Pressure Range "E"
(1440 LPH at 2.4 Bar)
Druckbereich „E"
25-90 PSID
Pressure Range "E"
25-90 PSID
(1.75-6.2 Bar)
25-90 PSID
(1.75 - 6.2 Bar)
(1.75-6.2 Bar)
Überdruck-Betriebszustand führen!
Modellnummer 52902-c
Model Number 51501
Model Number 52902-c
Fuel Pressure Regulator
Elektrischer Benzindruckregler
Electronic Fuel Pressure Regulator
C
A
U
T
I
O
N
!
C
A
U
T
I
O
N
!
C
A
U
T
I
O
N
!
C
A
U
T
I
O
N
!
A
R
N
I
N
G
!
A
R
N
I
N
G
!
W
A
R
N
I
N
G
!
W
A
R
N
I
N
G
!
Adjustment Screw
Adjustment Screw
(2X) -910 O-ring
Plug
Jam Nut
-906 O-ring
Flat Washer
Jam Nut
Flat Washer
(3X) Bracket Lock Washers
(3X) Bracket Lock Washers
Electronic Regulator
Regulator
Barbed Fitting
Barbed Fitting
Bracket
(3X) Bracket Screws
Bracket
(3X) Bracket Screws
Electrical Plug and Wire
109020122-1, Rev A
Sheet 1 of 6
109020122-1, Rev A Seite 1 von 6
105020121-1, Rev B
Sheet 1 of 4