Periodic Maintenance; Control Of Oil Level And Refreshing Pump Oil; Control Of Oil Level And Refreshing Reduction Gearbox Oil - Dibo JMB-C+ sreries Originalbetriebsanleitung

E N
S E R V I C E

Periodic maintenance

2
DESCRIPTION
• Check the electric cables, high &
low pressure hoses, couplings &
control of the oil level
• Check the wheel bolts, ball clutch,
plug, lights/brake lines, good tyre
pressure of the trailer
Refreshing pump oil
Refreshing reduction gearbox oil
Cleaning water filter(s)
Replacement and cleaning oil filters
and fuel filters
Cleaning fuel tank
Change the alternator belt
• all following refreshments of pump
oil and reduction gearbox oil
• Cleaning heat exchanger (de-
pending fluid properties & calcium
deposits)
Refreshing engine oil
Extra control/replacement of joints,
valves, o- rings by acknowledged
DiBo technicians
• lubricate or oil all sliding or jointed
parts of the overrun device
• Check on possible wear of the
wheel brakes, bearings, brake lining
• Replace the coolant of the engine

Control of oil level and refreshing pump oil

3
Check for each use of the machine, the oil with the oil level glass or with the oil
level bar. oil must stand right with the sign of the oil level glass, if this is not, oil
tops up until the sign. If oil looks milky, consult directly the DiBo technicians.
To refresh oil, follow instructions below:
• unbolt the drain plug below the pump.
• unbolt the tap with the oil level bar.
• Catch all oil in a barge and remove oil like further described in the guide.
• Force up the drain plug there and top up the oil in the breach to the upper
part to on the mark line.
• Force up the tap with the oil level bar there.
• Recommended oil: 1.836.042 (+- 1ltr, depending the pump).

Control of oil level and refreshing reduction gearbox oil

4
Check for each use of the machine, the oil with the oil level glass. oil must stand
right with the sign of the oil level glass, if not the case, refill the oil up to the
mark sign. If oil looks milky, consult directly the DiBo technicians. To refresh oil,
follow instructions below:
• unbolt the drain plug below the reduction gearbox.
• Catch all oil in a barge and drain the dirty oil in an environmentally friendly
manner.
• Tighten the drain plug (with new seal ring) and top up the oil to the upper part
till the mark line.
• Recommended oil: 1.836.015 (0.35 ltr).
DiBO 34
PERIOD
after each use
First 50 hours
First 50 hrs hrs
First 50 hrs
First 50 hrs, every next 250 hrs
First 50 hrs, every next 250 hrs
Every 500 hrs. yearly.
Every 250 hrs
See motor instruction manual
Every 750 hrs
yearly