Manual Start - Zoef Robot HARM 2.0 Gebrauchsanweisung

User Manual
If you want to change the code
Start by pressing the factory code 0000 + START.
The machine leaves the docking station and starts operating.
After a few meters • press STOP - error code E1 appears on the display.
• Press START and hold the START button for 10 seconds until the code U133 appears on the display.
• Press SET. The lock icon (image) ashes. Press the factory code 0000 one by one with OK,
until 0000 is lit continuously.
• Press SET again and the lock icon ashes.
Now • press the 4-digit security code that you have personally chosen and then press OK.
Your personal security code has now been set and is lit continuously.
Finally, press START and the machine will continue to run.
DON'T FORGET YOUR CODE!
Note: If you forget your personal code, the machine must be sent to the distributor to be reset.