Herunterladen Inhalt Inhalt Diese Seite drucken

Perel Tools PJS05001 Bedienungsanleitung

Pendelhub-stichsäge 500w

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

1. Introduction & Features
To all residents of the European Union
Important environmental information about this product
This symbol on the device or the package indicates that disposal of the device after its lifecycle could harm the environment.
Do not dispose of the unit (or batteries) as unsorted municipal waste; it should be taken to a specialised company for recycling.
This device should be returned to your distributor or to a local recycling service.
Respect the local environmental rules.
If in doubt, contact your local waste disposal authorities.
Thank you for buying the PJS05001! Unpack the device. Please check carefully that there is no damage caused by
transportation. Should there be any, consult your dealer and don't use this device.
2. General Safety Instructions
Keep this device away from
rain and moisture.
Do not expose charger and battery
to temperatures above 50°C.
Recycle the battery in an
environmentally safe way.
Wear protective goggles.
• Make sure to respect all national safety regulations concerning installation, operation and maintenance.
• Damage caused by disregard of certain guidelines in this manual is not covered by the warranty and the dealer
will not accept responsibility for any ensuing defects or problems.
• Do not switch the device on immediately after it has been exposed to changes in temperature. Protect the device
against damage by leaving it switched off until it has reached the ambient temperature.
• This device falls under protection class II.
• Make sure that the available voltage does not exceed the voltage stated in the specifications of this manual.
• Do not crimp the power cord and protect it against damage. Have an authorised dealer replace it if necessary.
• Disconnect the device from the mains to clean it or when it is not in use. Handle the power cord by the plug only.
• Never let the power cable get in front of the device while it is being used!
• All modifications of the device are forbidden for safety reasons. Damage caused by such modifications is not
covered by the warranty. Never overload the machine!
• Keep the device away from children and unauthorised users.
PJS05001
PJS05001 – JIGSAW 500W
Disconnect from mains before starting
maintenance operation.
Do not incinerate batteries.
Wear a mask in dusty conditions.
Always wear protective gloves.
1
Do not operate this device
while the housing is open.
Do not expose charger
or battery to water
Wear ear-muffs. Loss of hearing can be
a gradual process.
Always wear a helmet.
PEREL

Werbung

Inhaltsverzeichnis
loading

Inhaltszusammenfassung für Perel Tools PJS05001

  • Seite 1 If in doubt, contact your local waste disposal authorities. Thank you for buying the PJS05001! Unpack the device. Please check carefully that there is no damage caused by transportation. Should there be any, consult your dealer and don’t use this device.
  • Seite 2: Specific Safety Instructions

    • Only use the device for its intended purpose. Using the device in an unauthorised way will void the warranty. • Always make sure you are in a stable position while using the PJS05001. • Make sure you can never touch water, electricity or gas lines while working.
  • Seite 3 Using the pendulum movement (fig. A) The pendulum action switch (8) is used to set the correct sawing angle for the subject material • Put the selector in the desired position (see table below). Material Position aluminium ceramics plastic rubber steel wood I-II PJS05001 PEREL...
  • Seite 4: Cleaning And Maintenance

    * measured according to EN 50144 Note: The EC Declaration of Conformity is attached. The information in this manual is subject to change without prior notice. PJS05001 – DECOUPEERZAAG 500W 1. Inleiding en kenmerken Aan alle ingezetenen van de Europese Unie...
  • Seite 5: Algemene Veiligheidsvoorschriften

    • Gebruik het toestel enkel waarvoor het gemaakt is. Bij onoordeelkundig gebruik vervalt de garantie. • Zorg er altijd voor dat u stabiel staat wanneer u de PJS05001 gaat gebruiken. • Zorg ervoor dat u geen water-, elektriciteits- of gasleidingen raakt wanneer u werkt.
  • Seite 6: Bijzondere Veiligheidsvoorschriften

    Het stof wordt afgezogen via de stofuitlaat en een stofzuiger • Bevestig de adapter (6) op de stofuitlaat (7). • Sluit een stofzuiger aan op de uitlaat d. Snelheidsregeling (fig. A) Regel de zaagsnelheid met de ronde knop (6). PJS05001 PEREL...
  • Seite 7: Reiniging En Onderhoud

    8. Indien u onderdelen nodig heeft, bestel dan originele onderdelen bij uw plaatselijke dealer. 7. Technische specificaties Voeding max. 230V~ / 50Hz Verbruik 500W Regelbare snelheid 500 - 3000rpm Max. snijdiepte 8mm (staal) 65mm (hout) Trillingsgraad 6m/s² Geluidsdrukniveau 88dB (A)* Geluidsvermogenniveau 100dB (A)* PJS05001 PEREL...
  • Seite 8: Introduction & Caractéristiques

    * gemeten volgens EN 50144 Opmerking: De EC Conformiteitsverklaring staat achterin de handleiding De inhoud van deze handleiding kan te allen tijde worden gewijzigd zonder voorafgaande kennisgeving. PJS05001 – SCIE SAUTEUSE 500W 1. Introduction & Caractéristiques Aux résidents de l'Union Européenne Des informations environnementales importantes concernant ce produit Ce symbole sur l'appareil ou l'emballage indique que, si l'appareil est jeté...
  • Seite 9: Consignes De Sécurité Particulières

    • Toute modification de l’appareil par l'utilisateur est interdite pour des raisons de sécurité. Le dommage consécutif ne tombe pas sous la garantie. • Gardez votre PJS05001 hors de la portée de personnes non qualifiées et de jeunes enfants. • Familiarisez-vous avec le fonctionnement de l'appareil avant de l’utiliser. Ne permettez pas aux personnes non qualifiées d'opérer cet appareil.
  • Seite 10 • Mettez le sélecteur dans la position désirée (voir table ci-dessous). Matériau Position aluminium céramique plastique caoutchouc acier bois I-II g. Interrupteur marche/arrêt • allumer pressez l'interrupteur • usage continu verrouillez l'interrupteur avec le bouton de verrouillage (3) • éteindre pressez l'interrupteur brièvement et lâchez-le PJS05001 PEREL...
  • Seite 11: Nettoyage Et Entretien

    II / Poids 2.3kg * spécification mesurée selon la norme EN 50144 Remarque: La déclaration de conformité est ajoutée à la fin de la notice. Toutes les informations présentées dans ce manuel peuvent être modifiées sans notification préalable. PJS05001 PEREL...
  • Seite 12: Introducción & Características

    Si tiene dudas, contacte con las autoridades locales para residuos. ¡Gracias por haber comprado la PJS05001! Desembale el aparato. Verifique si el aparato ha sufrido algún daño en el transporte antes de la puesta en marcha. Si es el caso, no conecte el aparato a la red y póngase en contacto con su distribuidor.
  • Seite 13 • Deslice una hoja en el soporte (2) y asegúrese de que la hoja de sierra deslice en la ranura del rodillo de soporte de la hoja (3) • Apriete los tornillos con la llave Allen. • Deslice la cubierta protectora hacia abajo. PJS05001 PEREL...
  • Seite 14: Limpieza Y Mantenimiento

    3. Las partes móviles no pueden mostrar ningún rastro de desgaste y deben estar bien equilibradas. 4. No dañe los cables de alimentación. Contacte con un técnico especializado para instalar el aparato. 5. Limpie el aparato regularmente con un paño húmedo y sin pelusas. Evite el uso de alcohol y de disolventes. PJS05001 PEREL...
  • Seite 15: Einführung Und Eigenschaften

    Nota: La declaración de conformidad está incluida al final del manual del usuario. Se pueden modificar las especificaciones y el contenido de este manual sin previo aviso. PJS05001 – PENDELHUB-STICHSÄGE 500W 1. Einführung und Eigenschaften An alle Einwohner der Europäischen Union Wichtige Umweltinformationen über dieses Produkt...
  • Seite 16: Spezifische Sicherheitsvorschriften

    • Sorgen Sie dafür, dass Sie keine Wasser-, Elektrizitäts-, und Gasleitungen treffen wenn Sie arbeiten. • Verwenden Sie die PJS05001 nicht in der Nähe von entflammbaren Dämpfen und brennbaren Materialien. • Erschütterungen können Verletzungen am Hand oder Arm verursachen. Hand oder Arm möglichst kurz den Erschütterungen aussetzen.
  • Seite 17: Bedienung

    • Stellen Sie den Abstand ein und schrauben Sie die Schrauben fest (1). f. Pendelbewegung (Abb. A) Der Pendelhub-Schalter (8) wird verwendet um den Winkel für das zu sägende Material einzustellen. • Stellen Sie den Wahlschalter in die gewünschte Position (siehe Tabelle). PJS05001 PEREL...
  • Seite 18: Reinigung Und Wartung

    500 - 3000rpm Max. Schnitttiefe 8mm (Stahl) 65mm (Holz) Erschütterungen 6m/s² Schalldruckpegel 88dB (A)* Schallleistung 100dB (A)* Schutzklasse II / Gewicht 2.3kg * gemessen gemäß EN 50144 Bemerkung: Die EC Konformitätserklärung steht am Ende der Bedienungsanleitung. Alle Änderungen vorbehalten. PJS05001 PEREL...
  • Seite 19: Ec Declaration Of Conformity

    It is hereby declared that following designated product(s): PENDULAR ACTION JIGSAW 500W (Type of equipment, description) PJS05001 (Model designation) complies with the essential protection requirements of Council Directive 89/336/EEC, 93/68/EEC and its amendments on the approximation of the laws of the Member States relating to electromagnetic compatibility.
  • Seite 20 It is hereby declared that following designated product(s): PENDULAR ACTION JIGSAW 500W (Type of equipment, description) PJS05001 (Model designation) complies with the essential protection requirements of European Community Directive 73/23/EEC, 93/68/EEC and its amendments on the approximation of the laws of the Member States relating to the Low Voltage Directive.

Inhaltsverzeichnis