Jet-Line POLLUX Bedienungsanleitung Seite 12

OPERATING INSTRUCTION
• Plug the patio heater into a dry, protected and grounded 220-240V, 50
Hz, 13 AMP power outlet.
• Only operate the heater when it is in an upright position.
•
Our electric patio heater "Pollux" is equipped with a pull cord switch.
•
To operate the heater with 1500W, pull the cord once.
• If you want to switch the heater off, just pull the cord once again.
Care and maintenance
Disconnect the device from electrical supply and give it time to fully cool off.
To keep the heater clean, please wipe its surface with a clean, damp cloth. If
required, you can also use a mild detergent. Do not use any corrosive or
solvent cleansers nor immerse the device in water. After cleaning, please rub
the heater dry with a clean cloth.
Do not use any corrosive or solvent cleansers, like alcohol, petrol, abrasive
cleaner, furniture polish or coarse brush, as these might damage the surface.
Although the device is suitable for outdoor use, you should never immerse it
in water for your own safety. Should the heater get wet, please make sure to
wait until it is fully dry before using it again
STORAGE
If you do not need the heater for a longer period of time it is suggested to store
it in a cool, dry location. To prevent it from being exposed to dust or dirt, it is best
to pack it in the original carton.
12