Samsung SWA-9100S Bedienungsanleitung Seite 5

4. Configure "ID SET" using the Soundbar's
s,
remote control
Press the Up button on the Soundbar remote control for 5 seconds.
• The ID SET message appears on the Soundbar main unit's display
for a short time and then disappears.
e
• After the ID SET process, the Soundbar power is automatically
turned on.
o
5 Sec
• The image of the Soundbar may differ from your Soundbar,
depending on the model.
5. Check if the LINK LED is solid blue
(connection complete)
STANDBY
LINK
STANDBY
LINK
The LINK LED indicator stops
blinking and glows a solid
blue when a connection is
established between the
Blue is On
Soundbar and the Wireless
Receiver Module.
6. If the SWA-9100S does not connect, take
the necessary steps according to the LED
Indicator's status
LINK (Blue) On : Connected with the Soundbar.
LINK (Blue) Blinking : Connection standby status.
• Check if the Soundbar is turned on.
• Repeat steps 3 through 5.
STANDBY (Red) On : Connection failure.
ID SET
• Check if the Soundbar is turned on.
• 1. Press the ID SET button on the back of the Wireless
Receiver Module with a pen tip for 5~6 seconds until the
LINK LED indicator blinks (in Blue).
2. Repeat steps 3 through 5.
Others : Errors
• Contact a Samsung Service Centre.
03 COMPATIBLE MODELS
• Compatible with select Samsung Soundbar. Please visit the
Soundbar product page at www.samsung.com/support for more
information.
• Compatible model list is subject to change without further notice.
04 OPEN SOURCE LICENCE
NOTICE
To send inquiries and requests for questions regarding open
sources, contact Samsung Open Source (http://opensource.
samsung.com)
5 Sec
L R ID SET
SURROUND SPEAKERS OUT
SPEAKER IMPEDANCE : 3
ID SET
POWER
English - 5