2.5" USB 3.0 & FireWire800
SATA HDD Enclosure
User Manual
Benutzerhandbuch
Manuel Utilisateur
Manuale
LINDY No. 43165
www.lindy.com
© LINDY ELECTRONICS LIMITED & LINDY-ELEKTRONIK GMBH - First Edition (NOV 2014)
Features
•
Combined External USB3.0/FireWire 800 enclosure for
2.5" SATA hard disk drives
•
Interfaces: 1 x USB 3.0, 2 x FireWire 800
•
Compatible with 2.5" SATA HDDs/SSDs (up to 12mm
height)
•
Solid Aluminum body for excellent heat dissipation and
hard drive protection
•
Backwards compatible with USB2.0/USB1.1 devices
•
Supports the following speed data rates: USB Super
Speed(5Gbps)/HighSpeed(480Mbps)/FullSpeed(12Mbp
s)/LowSpeed(1.5Mbps),FireWire1394b(800Mbps)
•
Hot Plug-and-Play
•
Active LED to indicate HDD status (lit-LED: HDD is
connected, LED blinking: read/write is underway)
•
Weight:136g
•
Size:125x79x22mm
System Requirement
•
Windows XP/Vista7/8 - automatic installation of drivers
from OS
•
Mac OS 10.x and higher - automatic installation of
drivers from OS
•
LINUX 3.x and higher - automatic installation of drivers
from OS
•
Available USB port or FireWire 800 port
Note: Do not connect via USB and FireWire port at the
same time!
English
Deutsch
Français
Italiano
English
Installation
1)
2)
3)
4)
5)
6)
7)
8)
Daisy Chain Connection
If you want to connect through FireWire you can take advantage
English
of 2 connectors and so called "daisy chain connection", which
enables you to connect to the computer via first FW port while
the other port can be used to connect to another FW enclosure.
You will then see both devices as independent drives in your
computer.
Power Issue
In case the driver does not have enough power from
USB/FireWire port we recommend to attach the included USB
DC adapter cable or an additional external power suppy DC 5V
(not included).
Unscrew the screws from the bottom part of the enclosure
and pull out the HDD tray
Connect the HDD to the electronic board
Screw the HDD to the inner part of the enclosure
Now insert the tray with HDD into the casing and attach it
with screws from the bottom side of the enclosure
Connect the cable (USB or FW) to the enclosure and
computer
Switch on the button on the rear panel of the enclosure
The driver will be recognized and installed automatically
You can start to use the device
English