Werbung
Verfügbare Sprachen
Verfügbare Sprachen
harness buckle by pressing on the red button in the centre of the buckle. Place
your child in the car seat. The folding armrests make it easier to install and access
the car seat. Put the harness buckle ends together and close the buckle, making
sure you hear a 'click' (14). Pull on the adjusting strap of one of the upper harness
sections until it is properly tightened against your child (15). Repeat the operation
GB
with the adjusting strap of the second upper harness section.
CAUTION: Before each journey, check that the armrests are lowered. A correctly
adjusted harness is essential for your child's protection. There should not be more
than a finger's width between the harness and your child.
Installation without the harness
Gr. 2-3, from 15 to 36 kg (from approximately 3 to 12 years)
Ensure that the harness of your car seat has been dismantled before starting to
install it in the vehicle.
•
Dismantling the harness: Press on the red harness button to undo the harness
if necessary. Repeat operations
(3)
and
(4)
on each upper section of the harness.
Grasp a section of the harness and thread it through the side openings of the cover
and the shell to the back (16), attach the metal anchor of the harness to the back
of the seat (17). The metal anchor must be positioned between the shell and the
car seat cover. Repeat the operation on the second section of the harness. Check
that the harness connectors have also passed behind the back rest. Lift the base
of the cover and thread the harness buckle through the crotch slot. The buckle fits
into a special compartment (18). Replace the cover.
Your car seat is fitted with an adjustable headrest that has been designed to sup-
port your child throughout growth by providing maximum side protection.
Raise the adjustable headrest to its highest position. Place the car seat against
the back seat of the vehicle
(19)
and feed the diagonal strap of the belt through
the headrest guide
(20)
(21). Sit your child in the car seat. The folding armrests
make it easier to install and access the car seat. Make sure that the child's back is
fully in contact with the back of the car seat. Pull and fasten the vehicle seat belt.
Pass the diagonal strap of the belt under the arm rest opposite the belt guide used.
The waist strap of the belt passes under both armrests (22). Lower the adjustable
headrest and adjust it to the height of your child (23). It should be positioned so
that it surrounds your child's head, providing maximum lateral protection, whilst
guiding the diagonal belt over the child's shoulder so that it doesn't extend onto
the child's neck
(24)
(25). Tighten the vehicle seat belt.
Make sure that the seat belt is properly tightened, that it is not twisted and that it
is not positioned at the level of your child's neck.
To remove your child from the car seat, simply unbuckle the seat belt and place it
at the side of the car seat. The belt will remain suspended from the headrest belt
16
GB - User guide
Werbung
