IKEA SVALKAS AA-2242483-1 Bedienungsanleitung Seite 21

ENGLISH
Problem
The lamp does not work.
There is too much frost and
ice.
There is too much frost and
ice.
There is too much frost and
ice.
There is too much frost and
ice.
There is too much frost and
ice.
There is too much frost and
ice.
Water flows on the rear plate
of the refrigerator.
There is too much condensed
water on the rear wall of the
refrigerator.
There is too much condensed
water on the rear wall of the
refrigerator.
There is too much condensed
water on the rear wall of the
refrigerator.
Water flows inside the refrig‐
erator.
Water flows inside the refrig‐
erator.
Water flows on the floor.
Possible cause
The lamp is defective.
The door is not closed cor‐
rectly.
The gasket is deformed or
dirty.
Food products are not wrap‐
ped properly.
Temperature is set incorrect‐
ly.
Appliance is fully loaded and
is set to the lowest tempera‐
ture.
Temperature set in the appli‐
ance is too low and the ambi‐
ent temperature is too high.
During the automatic de‐
frosting process, frost melts
on the rear plate.
Door was opened too fre‐
quently.
Door was not closed com‐
pletely.
Stored food was not wrap‐
ped.
Food products prevent the
water from flowing into the
water collector.
The water outlet is clogged.
The evaporative tray above
the compressor is not placed
below the melting water out‐
let.
Solution
Contact the nearest Author‐
ized Service Centre.
Refer to "Closing the door"
section.
Refer to "Closing the door"
section.
Wrap the food products bet‐
ter.
Refer to "Control Panel"
chapter.
Set a higher temperature. Re‐
fer to "Control Panel" chap‐
ter.
Set a higher temperature. Re‐
fer to "Control Panel" chapter
and "Location" section.
This is correct.
Open the door only when
necessary.
Make sure the door is closed
completely.
Wrap food in suitable pack‐
aging before storing it in the
appliance.
Make sure that food products
do not touch the rear plate.
Clean the water outlet.
Make sure the tray is placed
below the melting water out‐
let.
21