Control Panel - Zelmer ZCL6030 Benutzerhandbuch

EN
Position the appliance away from:
- sources of heat (e.g. open flames, gas ovens, etc.)
- deposits of liquids (e.g. sinks, etc.) to avoid falling into or splashing with water (minimum distance 2
metres)
fabrics (curtains, etc.) or loose materials, which may obstruct the ventilation grille; in addition, check that
the front part is free of volatile materials (dust, etc.).
The supporting surface must be stable, flat and even (so that the appliance does not tip over).
USE
Before each use check that the appliance is in good condition and that the electric cable is not damaged;
if the electric cable is damaged, it must be replaced by the manufacturer or by the technical assistance
service or, in the event, by a qualified technician, in order to avoid any type of danger.

CONTROL PANEL

• Speed: press the button high, medium or low and the appliance will run at that speed.
• Osc: press the touch "swing", the louver will start to oscilate.
• Cool: Touch "cool", cool function start working.
• Once pressing on/off button twice, the appliance will stop working.
Note: the ice box should be far away from children to avoid eating.
Insert the power cord to the mains.
Press the on/off button to start the fan.
Fan function: Select the desired speed.
Cooling function: To avoid damaging the appliance, do not press that function if the water tank is
empty.
Before operating the unit in Cool mode, make sure the water tank escape valve is properly fixed.
Add clean water respecting the water level indicator (Min and Max).
You can add water from the tank or opening the top lid.
Press the button Cool and the unit should commence to blow cooler air. When you press the button Cool
again, it will stop working.
If you found the air not cool enough, you can add additional ice block (11).
Open the ice block and fill them with water. Place the ice blocks filled of water into the freezer for 2 hours
and then, place them back to the water tank.
During long periods of inactivity, disconnect the plug from the mains socket.
MANITENANCE AND CLEANING
Warning: before carrying out the normal cleaning operations, remove the plug from the mains socket.
To clean the appliance, use a soft, slightly damp cloth; do not use abrasive or corrosive products.
Do not immerse any part of the appliance in water or any other liquid: if this happens, do not immerse
your hand in the liquid and, first of all, remove the plug from the mains socket.
Dry the appliance carefully and check that all the electrical parts are not wet: if in doubt, contact a
qualified technician.
In order to avoid the creation of odors and ensure the unit works properly, it must be cleaned internally
once every two weeks.
Remove the back panel, by loosening the two attachment pins and lifting the panel upwards, off the 2
upper attachment points. Remove the filter and the honeycomb filter from the unit.
Wash the filter in warm water with a mild, soapy solution; use a soft brush if necessary. Rinse with clean
water and leave to dry.
Wash the honeycomb filter with clean water and a soft brush if necessary. Leave to dry.
Empty the water tank and clean with water, a mild soapy solution and a soft brush if necessary. Rinse
10