Technical Specifications - Weelko TWINWAXER WKE010 Bedienungsanleitung

CONTENT
On arrival of the parcel, check the pre-
sence of the following items:
- Double-tank wax heater
6. Indicator
OPERATION
1. Place the equipment onto a flat surface.
2. Put some wax into the equipment and close the
lid.
3. Turn on the power switch and regulate the tem-
perature of the higher tank up to the maximum
one so that the wax gets melted. Once the indica-
tor light turns off, the unit has reached the wished
temperature. Then adjust the temperature of the
lower tank to the suitable one to start working.
4. Before applying the wax onto the patient's skin,
the temperature should be firstly tested. Start
the treatment once the suitable temperature is
reached.
5. Clean the skin before starting the treatment.
6. Spread the wax onto the skin following the
direction of the hair growth. The thinner the wax
layer is, the easier the hair removal becomes. Do
not surpass the paper band surface. Use your
hand to smooth the paper band to the direction of
the hair growth. Use one hand to hold the paper
band tightly and use the other one to press the
band against the skin.
7. Pull off quickly in the opposite direction of the
hair growth when the wax has got dry.
1. lid
3. Structure
4 ON/OFF
REMARKS
EN
Before use
o Do not leave children unattended with
this appliance.
o Do not use it on any person with sensi-
tive skin or with a skin disease.
o Make sure the equipment is dry inside
before using it.
2. Handle
o Check the technical specifications of
the equipment according to the ones of
your country before starting its opera-
tion.
While operation
o Do not keep the equipment in a wet
5. Temperatu-
environment or next to water.
re regulator
o Stop using the equipment if there is
any fault or any component seems to be
broken.
o Once the equipment is working, do not
touch the aluminum pot. Use a special
tool to handle the wax pot.
o Do not leave the equipment unattended
while working.
After use:
o Once the treatment is finished, turn off
the power switch and unplug the equip-
ment if you are not immediately using it
again.
o Do not apply water directly to the equi-
pment to clean it. The equipment can
only be cleaned with alcohols or specia-
lised wax removal products.
o If the equipment is damaged or broken,
prevent the manufacturer. Do not ma-
nipulate it without its instructions or
authorisation.

TECHNICAL SPECIFICATIONS

CAPACITY
OUTER DIMENSIONS
INNER DIMENSIONS
RATED VOLTAGE
RATED POWER
TEMP. RANGE
2.5 + 2.5l = 5l
50 × 24.5 ×
24.5cm
Ф17.5/ Height:
13cm.
AC 220-240V
50/60Hz
500 w
0- 105ºC