Operation; Technical Specifications - Weelko Monowaxer WKE009 Bedienungsanleitung

CONTENT
On arrival of the beauty bed, check the
presence of the following items:
- Single-tank wax heater

OPERATION

1. Place the equipment onto a flat surface.
2. Put some wax into the equipment and
close the lid.
3. Turn on the power switch and regula-
te the temperature up to the maximum
one. Once the indicator light turns off, the
equipment has reached the wished tem-
perature and you can start working.
4. Before applying the wax onto the pa-
tient's skin, the temperature should be
firstly tested. Start the treatment once
the suitable temperature is reached.
5. Clean the skin before starting the treat-
ment.
6. Spread the wax onto the skin following
the direction of the hair growth. The thin-
ner the wax layer is, the easier the hair
removal becomes. Do not surpass the
paper band surface. Use your hand to
smooth the paper band to the direction of
the hair growth. Use one hand to hold the
paper band tightly and use the other one
to press the band against the skin.
7. Pull off quickly in the opposite direction
of the hair growth when the wax has got
dry.
1. Lid
2. Handle
3. Structure
4. Temperature
regulator
6. Power switch
REMARKS
EN
Before use
o Do not leave children unattended with
this appliance.
o Do not use it on any person with sensi-
tive skin or with a skin disease.
o Make sure the equipment is dry inside
before using it.
o Check the technical specifications of
the equipment according to the ones of
your country before starting its opera-
tion.
While operation
o Do not keep the equipment in a wet
environment or next to water.
o Stop using the equipment if there is
any fault or any component seems to be
broken.
o Once the equipment is working, do not
touch the aluminum pot. Use a special
tool to handle the wax pot.
o Do not leave the equipment unattended
while working.
After use:
o Once the treatment is finished, turn off
the power switch and unplug the equip-
ment if you are not immediately using it
again.
o Do not apply water directly to the equi-
pment to clean it. The equipment can
only be cleaned with alcohols or specia-
lised wax removal products.
o If the equipment is damaged or broken,
prevent the manufacturer. Do not ma-
nipulate it without its instructions or
authorisation.

TECHNICAL SPECIFICATIONS

CAPACITY
OUTER DIMENSIONS
INNER DIMENSIONS
RATED VOLTAGE
RATED POWER
TEMP. RANGE
2,5 l
24.7 × 24.5 ×
16cm
Ф17.5 / Profundi-
dad: 13cm.
AC 220-240V
50/60Hz
350 w
0- 105ºC