Connection Schemes - Lighting Technologies WASHLINE LED Serie Montageanleitung

1. Unpack the luminaire, attach it to bearing surface with adjustable brackets (on fig. A - bracket,
B – distribution box, C - sealed connector, D - stub).
2. Bring mains/control cables using terminal blocks and junction box (not included in luminaire's
delivery set). Cable connection sholuld be done with appropriate polarity: ground, "L1" - phase,
"N" - neutral.
3. Seal cable entry in the junction box (with special flanges and silicone).
4. Connect the luminaire to the mains with leader cable and sealed connector (not included), or
sealed junction box, lock the joints.
5. Interconnect luminaries in a line with terminals block (line's length is limited by 1.5 mm wiring
cross-section and overall power of the line), lock the joints, place the plug (D) at the end of the
line, or seal the cable.
6. Set the luminaire in desired position with pivoting brackets and lock it with screws.
These instructions assume expert knowledge corresponding to a completed professional
Overall and installation dimensions, mm
1.
2.

CONNECTION SCHEMES

1. Mains connection scheme.
education as an electrician.
5