Description; Control Knobs - TREVIDEA G3 FERRARI TEPOR G60021 Bedienungsanleitung

the plug from the electrical outlet and wait for the
complete cooling of each part of the unit.
- Before each use, unroll the power cord completely.
- Do not insert anything in the protective grid. Not to
obstruct it and place the unit half a meter from the
surrounding objects. Pay attention: the protection grid
becomes very hot during use.
- Place the unit on solid and stable surfaces. During use,
place leave at least half a meter on each side of the unit.
- Do not use the unit near steam or water (sink, shower,
toilet ...). Do not use as a shelf support for objects.
- Do not cover for any reason, subject to overheating.
- Do not use in rooms smaller than 4 square meters.
The product is equipped with an automatic switch-off that
comes into play in case of overheating. If the product fails
during use, check that the ventilation openings are not
blocked, unplug the unit and allow to cool down for 15
minutes before operating.
WARNING: Do not use this heater in small rooms
when they are occupied by persons not capable of
leaving the room on their own, unless constant
supervision is provided.
The appliance must not be placed immediately below a
power outlet.
1. Working light
3. Function and temperature control knob
5. Air outlet grid

CONTROL KNOBS

The function knob (3) has the following modes:
- "O" means the product is off
- : fan without heating
- "1": low heating power (1000W)
- "2": highest heating power (2000W)
Turning the knob (3) to the left, heating remains at the high power and is possible to set the ambient
temperature.
DESCRIPTION G60021
2. Handle (in the back)
4. Swing button (in the back)
6. Main body 7. Resting base
11