Description Of The Appliance (Fig. 1) - eta 0622 Bedienungsanleitung

air flow, and let the appliance cool down for about 10 minutes. If the cut-out occurred for
reasons other than air flow reduction (e.g. motor bearing is seized), have the appliance
repaired by a specialised service centre.
– Do not modify the appliance surface in any manner (e.g. by self-adhesive wallpapers,
foils, etc.)!
– When handling the appliance, avoid causing any injury (e.g. burns).
– Before every connection or disconnection of the appliance from power supply make sure
that switch A1 is in 0 position.
– Do not place any device with open flame in the air flow coming out from the appliance
because of danger of burning process interruption.
– Never expose yourself (or animals) to the air flow for an extended period of time.
It may cause health problems.
– Only use original components designed for this type.
– Never put fingers or other objects into inlet and outlet holes of the fan.
– Check the condition of the power cord of the appliance regularly.
– Never put the power cord on hot surfaces and never let it hang over table edge or worktop
edge. If the cord is caught or pulled, e.g. by children, the appliance may overturn and fall
down, causing a serious injury!
– Avoid winding the power cord around the appliance, otherwise the power cord service
life would be reduced.
– If you need to use an extension cord for justified reasons, it must be undamaged
and comply with the applicable standards.
– Only use this appliance for the purpose it was designed for, as specified in this manual.
Never use the appliance for any other purpose.
– WARNING: There is a risk of injury when the appliance is not used correctly
(not in accordance with the manual).
– All texts in foreign languages and pictures shown on the packaging or the product itself,
are translated and explained at the end of this language mutation.
– The manufacturer assumes no responsibility for any damage caused by improper handling
of the appliance and its accessories (e.g. electric shock, fire), and the appliance guarantee
will become void if any of the aforementioned safety instructions are not observed.
II. DESCRIPTION OF THE APPLIANCE (Fig. 1)
A – ventilator
A1 – multifunctional turning switch
A2 – turning thermostat regulator
A3 – handle for carrying
A4 – power cord
A5 – overturn safety fuse (the fan can be turned on only when it is pressed)
III. INSTRUCTIONS FOR USE
Remove all the packing material and take out the ventilator. Remove all possible adhesion
foils, stick-on labels or paper from the appliance. Place the ventilator on a suitable place.
Plug power cord connector A4 to an electric socket. Set the required position (function)
by turning switch A1, also set the required temperature by turning regulator A2.
When control light A3 is on, it signals that the appliance is connected to power supply and
it is in operation. Switch off the ventilator by turning switch A1 into position 0. The ventilator
can be held and carried using handle A3.
15 / 52
GB