Commissioning; Use; Adjusting The Speed; Switching On And Off - CIBO original Finitube SMFT 2018 Leitfade

EN
7.

COMMISSIONING

Before plugging in, check that the rated
mains voltage and mains frequency, as
stated on the type plate match your power
supply.
Always install an RCD with a maximum trip
current of 30 mA upstream.
8.

USE

8.1 Adjusting the speed

Set the recommended speed at the thumb-
wheel (10). (small number = low speed; large
number = high speed)

8.2 Switching On and Off

Always guide the machine with both
hands.
Switch on first, then guide the accessory
towards the workpiece.
The machine must not be allowed to draw
in additional dust and shavings. When
switching the machine on and off, keep it
away from dust deposits. After switching off the
machine, only place it down when the motor
has come to a standstill.
Avoid inadvertent starts: always switch the
tool off when the plug is removed from
the mains socket or if there has been a
power cut.
In continuous operation, the machine
continues running if it is forced out of your
hands. Therefore, always hold the machine
with both hands using the handles provided,
32 Ι Finitube
stand securely and concentrate.
0
Switching on: Push the sliding switch (7)
forward. For continuous activation, now tilt
downwards until it engages.
Switching off: Press the rear end of the sliding
switch (7) and release the sliding switch.
9.

CLEANING

It is possible that particles deposit inside the
power tool during operation. This impairs the
cooling of the power tool. Conductive build-
up can impair the protective insulation of the
power tool and cause electrical hazards.
The power tool should be cleaned regularly,
often and thoroughly through all front and rear
air vents using a vacuum cleaner or by blowing
in dry air. Prior to this operation, separate the
power tool from the power source and wear
protective glasses and dust mask.

10. TROUBLESHOOTING

The electronic signal display (9) lights
up and the load speed decreases. There
is too much load on the machine! Run the
machine in idling until the electronics signal
indicator switches off.
The electronic signal display (9) flashes
and the machine does not start. The
restart protection is active. If the mains
plug is inserted with the machine switched on,
Manual
Finitube
7
I