Operation; Choosing A Location; Getting Started; Other Features - Airthereal MA10K-PRODIGI Bedienungsanleitung

OPERATION

Choosing a location

1. Place the unit at least 15 inches away from TVs, radios, and other electronic products.
Make sure there's plenty of space for Ozone to be exhausted from the machine.
2. Before beginning ozone treatment, thoroughly clean up the source of the odor first.
DISCLAIMER:
Please make sure the operating voltage is the same as shown on the parametric label.
This unit will not function properly using in conjunction with external devices that alter
or convert voltage or frequency of electricity.

Getting Started

1. Insert the power cord into an electrical outlet.
2. Close all windows and doors to completely seal the room. Please note that all ozone
machines have to be used in unoccupied space only.
3. Press Power Button to turn the power on. When turned on, the LCD will light up, and
the Fan Speed and Ozone Control will be twinkling.
4. Choose your settings, then exit the room while ozone is being produced. After 5
seconds, the unit will produce ozone according to the default settings. By default,
the unit will run with the lowest ozone output (2g/h) and the minimum fan speed
(40 CFM).
NOTE: This unit comes with a 5-second delay for ozone generation. Once you select
the operating mode, the 5-second delay will start counting down. When the 5-second
delay countdown ends the unit will start operation, which gives users enough time to
leave without breathing in ozone directly.

Other Features

Fan Speed
Press to switch between 5 different speeds of air circulation to control the ozone
diffusion. Each press will cycle between 40 CFM→ 60 CFM → 70 CFM →
85 CFM → 100 CFM →40 CFM...
Ozone Control
Press to select the right ozone output according to the room sizes and air problems.
Each press will cycle between 2 g/h → 4 g/h→ 6 g/h → 8 g/h → 10 g/h →
2 g/h...
7