Dryfix CBD50 Bedienungsanleitung Seite 31

7. TROUBLESHOOTING
Symptom
 Check the power connection in securely.
 Check if the water level indicator lights
The unit is not
operating.
 Check the room temperature.
 Check the air filter for dirt.
 Check if the air duct is blocked.
There is little
formation of
 Check if the room temperature is below
condensate.
 Set humidity level is higher than current
 Overflow while moving the unit.
Water Leakage
 Check if the drain hose is kinked or
 Check if the unit is securely positioned.
Excessive Noise  Check if any loose, vibrating parts.
 Noise sounds like water flowing.
E1  Temperature sensor failure
E2  Humidity sensor dampened or failure.
 Display when Room temperature is
CL
Error
 Display when Room temperature is
Codes
CH
 Display when Room relative humidity is
LO
 Display when Room relative humidity is
HI
Inspection
up?
20℃.
Humidity value.
bends.
below 5°C（41°F）.
above35℃（95°F）.
bellow 20%RH.
above 95%RH.
 Insert the power cord securely into the wall
Outlet.
 Empty the water tank and reinstall correctly.
 The range of operating temperature is 5-
35℃.
 Clean the air filter as necessary.
 To clear the obstacle.
 This is normal. Low humidity in low
temperature environment.
 Set the humidity level below current
humidity value.
 Empty the water tank before transport.
 Straighten the hose to avoid a trap existing.
 Place the unit on horizontal and firm
ground.
 Secure and tight the parts.
 Noise comes from flowing refrigerant. This
is normal.
 Check connection or replace it.
 To clean or replace the humidity sensor.
 Normal. The compressor stops, and the fan
keeps running.
 Normal. The compressor stops, and the fan
keeps running.
 Normal. The compressor stops, and the fan
keeps running.
 Normal. The compressor and the fan keep
running.
31
Solution