Kress 500 bs Bedienungsanleitung Seite 6

English
6
1 Illustration
1 Keyless chuck
2 ON-/OFF-switch with electronics
3 Latch for mains cable module
4 Mains cable module
5 Holding button for continuous operation
6 Rotational direction switch
Accessories illustrated or described are not always
included as standard delivery items.
2 Application
The all-purpose power drill is for drilling and screwing
in wood, metal and plastic.
Safety Instructions and
3
Accident Prevention
Before operating the machine, please read through
the operating instructions completely, follow the
Safety Instructions in this manual as well as the gen-
eral Safety Instructions for Power Tools in the
accompanying booklet.
Caution!
– Befor fitting tools in the chuck or drill Spindle dis-
connect the machine from power supply!
– Do not work with materials which contain asbestos!
– Outside power sockets must be protected with
residual-current-operated circuit-breakers
(r.c.c.b.).
– For the attachment of identification markings on the
machine, do not drill into the housing. The protec-
tive insulation would be shorted. Use stickers.
– Always lead cables away towards the back of the
machine.
Double Insulation
Our equipment is designed in accordance with Euro-
pean regulations (EN standards) for the utmost safety
of the user. Machines with double insulation always
carry the international
not require earthing. A two-core cable is sufficient.
The machines are interference-suppressed in accord-
ance with EN 55 014.
. symbol. The machines do
4 Technical Data
Electronic drill
Input
Output
No-load speed
Adjustment range
Max. drilling capacity into steel
Max. drilling capacity into wood
Max. screwing into wood
Max. screwing into sheet metal
Euro collet
Measurement accross the corner
Chuck dia. Ø
Spindle thread
Weight
5 Putting into Operation
Before the first operation check that the mains voltage
corresponds to that given on the machine nameplate.
Trigger switch with button for continuous
operation
The machine is set in operation by pressing in the
handle switch 2. The holding button 5 on the side of
the switch can be pressed for continuous operation.
To release the continuous operation merely depress
the switch, which makes the holding button spring
back automatically.
Electronic speed control
This machine is fitted with a full-wave switch. The
speed can be controlled infinitely variably in the range
0 - 3000 r.p.m. and adapted for processing various
materials and applications.
Ensure that the drill is not allowed to jam for longer
than 2 - 3 seconds. Longer jamming can lead to motor
damage.
Important!
Continuous operation under strong load and low
speed can overheat the motor.
Allow the motor to cool down in no-load when set at a
high speed.
Rotational direction switch
Pressing the rotation direction switch 6 as far as it will
go causes the drill to rotate in the corresponding direc-
tion.
Attention! Change direction of rotation only
when the motor has ceased turning!
500 BS
500 BS
500 W
255 W
0 - 3000 r.p.m.
0 - 3000 r.p.m.
10 mm
16 mm
6 mm
5.3 mm
43 mm
22.5 mm
1 - 10 mm
3/8"-24 UNF
1.6 kg