Thicknesser - Zipper Maschinen ZI-HB254 Betriebsanleitung

Planing of small workpieces or Planks
Set the planing shaft cover so that only the
part of the planer shaft remains free, which
is required for the planing process. Parallel
stop to 90 °, adjust depth of cut, and slide
workpiece as shown on picture over the
worktable.
This manual does not replace professional training in working with planer
machines.

Thicknesser

Connecting dust chute.
Slide the fence to right side and turn to 135°. Remove the
blade guard and place the dust chute. The dust chute is so
positioned that both keys are in line with the longitude
holes. Then push both keys into the longitude holes.
.
 Adjust the desired height by means of the hand crank. A full rotation is 3mm
height difference.
 When setting the inlet height, observe the maximum depth for cut of 2.0 mm.
 Always ensure low friction of the thickness planing table by using special
lubrication oil for planing.
 Stuck workpieces may only be removed after the machine has been switched off
and disconnected from the power supply.
 Workpieces that are too short should not be processed.

Always assemble the dust chute (planing or thick planing) and ensure that the
keys are pushed (this press the safety switch!)!
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
ZI-HB254 23
A t t e n t i o n
A C H T U N G
OPERATION
23