Werbung
Attach Display to Stand
Loosely install two "C" Button Head Screws to the Display Brackets to roughly
half the length of the screw body. These two screws will temporarily support
the Display on the Stand. Note: There are six available Display height positions
on the Stand. Locating the two screws in the Display Bracket's top holes (as
shown) will work for the top four Display height positions. For the remaining
bottom two Display height positions, install these two locating screws in the
middle two holes in the Display Bracket.
Loosely install two 1/4 - 20 x .5 Button Head Screws to the Display Brackets to roughly half the length of the screw body.
These two screws will temporarily support the Display on the Stand. Note: There are six available Display height positions
on the Stand. Locating the two screws in the Display Bracket's top holes (as shown) will work for the top four Display
height positions. For the remaining bottom two Display height positions, install these two locating screws in the middle
two holes in the Display Bracket.
Salamander Mobile Interactive Display Stands
Leave half of
screw body exposed.
Use middle hole locations for two lowest Display Heights.
501-695 [7.18]
page 8 of 21
Werbung
