Maestro MR256 Bedienungsanleitung Seite 7

EN
device itself or the water.
- If there appears smoke, sparkling, strong smell of burning
isolation, immediately stop using the device, disconnect the
device from the mains and apply to the nearest service center.
Operation
Before startup
- Remove all wrap materials and stickers
- Make sure that all the parts of appliance don't have damages.
- Unwind the power cord completely.
- Place the device on a flat dry heatproof surface.
- Connect the device to the mains.
The hair must be clean, dry and brushed.
ATTENTION! A small quantity of smoke or a specific smell may
appear after the first switching ON as the result of conservation
materials contact with heating element. This is a normal
phenomenon and it shall disappear after several minutes of
operation.
- To switch the device ON move the switch (6/Fig.1) forward to
the position «ON», light indicator will flare (7/Fig.1), the device
will begin warming up.
- Wait until the tongs become warm. Required temperature will
be reached within 3 minutes approximately.
- The hair must be clean and dry without any gel, spray, etc. Use
the strands of hair maximum 2 cm wide and 1 cm thick.
- Place the ends of hair in the curling iron with open retainer,
7