Samsung SWA-9000S Bedienungsanleitung Seite 11

7. Check if the LINK LED is solid blue (connection complete)
STANDBY
LINK
8. If the SWA-9000S does not connect, take the necessary steps
according to the LED Indicator's status
LINK (Blue)
STANDBY (Red)
Others
STANDBY
LINK
Blue is On
LED status
Connected with
On
the Soundbar
Connection
Blinking
standby status
On Connection failure
- Errors
The LINK LED indicator stops blinking
and glows a solid blue when a
connection is established between the
Soundbar and the Wireless Receiver
Module.
-
Check if the Soundbar is turned on
Repeat steps 4 through 7.
Check if the Soundbar is turned on
1. Press the ID SET button on the back
of the Wireless Receiver Module with
a pen tip for 5~6 seconds until the
LINK LED indicator blinks (in Blue).
SURROUND SPEAKERS OUT
SPEAKER IMPEDANCE : 3
2. Repeat steps 4 through 7.
Contact a Samsung Service Centre.
ENG - 11
Action
5 Sec
L R
ID SET
ID SET
POWER