Appendixes A. Connection Settings; Appendice; Anhang; Apéndice - Star TCP400 serie Benutzerhandbuch

Appendix A: Connection Settings
A-1. RS-232C Interface
< RS-232C Serial Interface Specifications >
1 Connectors
2 Compatible Connectors
3 Connector Pins
4. I/O Circuit
5. Level
6. Cable
Pin No. Signal Name
1
2
3
4
5
6
7
8
9
< Settings for Communication Speed >
To change the serial communication settings, change the following DIP switch settings.
(Ex-factory Default Settings: DSW 1 to 6 are ON, 7 and 8 are OFF.)
Switches
DSW 1-1
Baud Rate Setting (See table below)
DSW 1-2
DSW 1-3 8 bit
DSW 1-4 Parity Disabled
DSW 1-5 Odd Parity
DSW 1-6 Fixed at On
DSW 1-7 Fixed at Off
DSW 1-8 Fixed at Off
Baud Rates BPS
DSW 1-1
DSW 1-2
* If incorrect switch settings are made, there may be a failure of the card reader/writer.
Be careful when making setting changes.
D-Sub 9PIN
D-Sub 9PIN
See Table Below
See Table Below
RS-232C
Cross (Reverse) Cable
I/O
NC -
RXD Input
XD Output
DTR Output
GND -
DSR Input
RTS Output
CTS Input
NC -
ON
Parity Enabled
Even Parity
4800 BPS 9600 BPS
OFF
ON
(Male) * Reader/Writer Side
(Female) * Cable Side
Functions
Not Connected
Reception Data
Transmission Data
Data Terminal Ready
Ground for Signal
Data Set Ready (Not Detected)
Transmission Request
Transmission Ready (Not Detected)
Not Connected
7 bit
19200 BPS
ON
ON OFF
– 81 –
OFF
38400 BPS
ON OFF
OFF