Werbung
Verfügbare Sprachen
Verfügbare Sprachen
CO-SLEEPING MODE (FIXED TO THE BED)
• It is possible to attach the crib to the parents' bed
(Co-Sleeping Mode).
• CAUTION – IMPORTANT FOR YOUR CHILD
SAFETY: This mode is only allowed with bed types
that allow you to comply with all the following
conditions:
• IMPORTANT: The reclined crib side must always be
placed next to the parents' mattress and the bed's
mattress must be aligned with (or at least higher
than) the height of the reclined crib side (see figure).
• When in the "Co-Sleeping Mode", the crib must
always be attached to the parents' bed frame with
the supplied strap, fixed as per the instructions.
• CAUTION: Check that the crib frame in "Co-Sleeping
Mode" is not interfering with the parents' bed.
• CAUTION: During use, make sure that sheets,
blankets, etc. do not fall inside the crib.
• CAUTION: Do not use when the child is able to sit,
kneel or stand up.
• IMPORTANT: The crib must be adjusted to the same
height on both legs.
• IMPORTANT: Place the crib against the longest side
of the adult bed.
• The process of fixing the crib to the bed and the
various adjustments must be carried out by an adult.
• In the "Co-Sleeping Mode", the crib must be fixed
to the adult bed.
• Place the crib next to the bed, adjust the height of
the crib so that the mattress is aligned with, or at
least higher than, the level of the reclined side.
• Lift up the bed mattress, place the strap locking
plate on the opposite side.
• Attach the two buckles to the crib. Tighten the
strap to securely anchor the crib in contact with the
mattress of the adult bed.
• IMPORTANT: There must be no gap between the
crib and the adult bed.
• Before each use, check that the crib is attached
by pulling it away from the adult bed. Tighten the
anchoring strap if necessary.
• DO NOT use the product if there is a gap between the
crib and the adult bed. Do not fill any gap between
the crib and the adult bed with cushions, blankets or
other objects as they may cause suffocation.
• Keep the anchoring straps out of the reach of
children.
-
warning
EN
• The dimension shall take into account that there
shall be no gap more than 30 mm between the
mattress and the sides end ends in any position of
the mattress.
• Do not use the product if any part is broken, torn or
missing and use only spare parts approved by the
manufacturer.
• WARNING – Do not use more than one mattress in
the crib (crib or suspended cradle).
• WARNING – To avoid a fire risk, never place the
product near electric heaters, gas stoves or other
sources of strong heat (crib or suspended cradle).
• Mattress dimensions: 842x480x50 mm.
• Suitable for cribs with maximum internal dimensions
of 872x510 mm.
MATTRESS - EN 16890:2017
WASHING
Werbung
