Bestron AWK1000M Bedienungsanleitung Seite 25

operation - overheating safeguard
The jug kettle is fitted with an overheating safeguard. This will switch off the jug kettle if it is operated
without (sufficient) water. Allow the jug kettle to cool down for at least 10 minutes before using it again.
cleaninG anD maintenance
1. Remove the plug from the wall socket, and allow the appliance to cool.
2. Clean the jug with a damp cloth. Never immerse the appliance in water. Never put the appliance in a
dishwasher. Make sure that the electrical connections do not become damp.
3. If the interior of the jug has become severely discoloured, then the best way to clean it is with a damp
cloth and a little washing soda. After cleaning, rinse the jug very thoroughly.
WARNING:
• N ever use corrosive or scouring cleaning agents or sharp objects (such as knives or hard brushes) to
clean the appliance.
• B efore cleaning, make sure that the appliance is not connected to the power supply and that it has
cooled down.
cleaninG anD maintenance - Descaling
Lime will be deposited on the inside depending on the hardness of the water. For this reason the appliance
must be cleaned at regular intervals.
1. Remove the plug from the wall socket, and allow the appliance to cool.
2. The jug kettle is fitted with a descaling filter. This filter must be removed for cleaning. Press the filter
inward through the spout (7). The filter will spring loose. You can take it out through the top opening by
turning the kettle upside down.
3. Fill the jug with a vinegar solution to the MAX level, and bring to the boil.
4. Leave the jug with the vinegar solution to stand for a couple of hours.
5. Empty the jug, fill with clean water to the MAX level, and bring to the boil. Empty the jug. Repeat this
process twice.
WARNING:
• N ever use ammonia or other products to descale the appliance. These can be injurious to your health.
Use solely a vinegar solution, or special descaling agents available from retailers.
25
EN