Cleaning & Maintenance - Pro-Elec PEL00939 Bedienungsanleitung

ASSEMBLY
Fitting the Feet
• Carefully turn the unit upside down.
Using the four 12mm screws provided,
affix the feet to the underside of the
heater (see right).
OPERATION
• Before connecting the appliance to the mains, make sure that all switches are set
to the "OFF" position.
• Insert the plug of the heater into the mains socket.
• Adjust the thermostat to a desired temperature level.
• Turn on the heating element using the two rocker switches on the side panel. They
will illuminate when the heating elements are on.
• Never pull on the cord when disconnecting from the mains.
Note: It is normal when the heater is turned on after a period of no use for it to emit
some odour. This will disappear after the heater has been on for a short time.
CLEANING & MAINTENANCE
• Always unplug the heater from the wall socket and allow it to cool down before
cleaning.
• Clean the outside of the heater by wiping it with a clean, damp cloth.
• Do not use any chemicals, abrasives or solvents that may damage the heater.
• Do not allow any water to enter the inner appliance.
• To store the heater, place it in a clean, dry environment, ensuring it is protected
from dust.
GB