Installing The Heater - Toyotomi Kerosun RS-2200 Gebrauchsanweisung

MANUAL
A

INSTALLING THE HEATER

1 Carefully remove your heater from the box and check the contents.
In addition to the heater you also need to have:
¼ a transportation cap
¼ these directions for use
Keep the box and the packaging materials (Fig. A) for storage and/or
transportation.
2 Remove the other packaging materials:
¼ Release the right side of the grill
side of the grill to the left and then pull it forward (Fig. B).
¼ Pull both ends of the packaging to the rear and at the same time slightly
downwards (see Fig. C).
¼ Remove the combustion chamber
packaging (see Fig. D).
¼ Put the combustion chamber back into its place. The combustion chamber
is positioned correctly when it can be smoothly moved a little to the left
and to the right by its handle ¿ (Fig. E). Close the grill: Slightly lift it to
reposition it in its slot.
¼ Open the lid of the removable tank
!
If the left side of the grill has been removed, first insert the flattened upper left
end of the grill into the upper left slot and then insert the other flattened end
into the lower left slot (Fig. F).
3 Fill the removable tank as indicated in Section B.
4 Insert the batteries into their holder µ at the back of the heater (Fig. G).
Ensure that the positive and negative poles match the + and - marks indicated
on the battery housing. It is best to use new alkaline batteries (4x C-size).
5 The floor should be firm and completely level. Reposition the heater, when it
is not level. Do not correct the situation by placing books or other goods
under the heater.
6 Your heater is now ready for use.
!
Do not use the heater at a height of over 1500 meters.
A
from the two slots by pulling the right
from the heater and remove the
and remove the piece of cardboard.
4
5