Chal-Tec ACO-CTR1 Bedienungsanleitung Seite 10

5-1.UP DOWN VANE button
Press the " UP DOWN VANE " button once or more, set up the outlet starting page or stop swinging around
air supply, at the same time corresponding instructions icon light or go out.
5-2.LEFT RIGHT VANE button
Press the " LEFT RIGHT VANE " button once or more, outlet yawing page starting or stopping air supply
bobbing up and down, and the corresponding instructions icon light or go out.
6. TIMER button
Set the time by pressing the timer button to select a desired timing level as follow, the range is between 0.5-
7.5 hours. The pilot light corresponding to the selected timing level will be illuminated.
7. MODE button
The default setting is Normal wind, and then you can press the button Mode again to choose your desired
wind mode as per the following sequence:
The wind mode selecting can be circulated and the wind mode pilot lamp will be on during the fan mode in
operating.
8. COOL button
Please noted that the COOL LAMP will flashing when you press the Cool button if there is no or
lacked water in water tank.
8-1 Before operating the unit in Cool mode, make sure the escape valve for the water tank is properly fixed.
Then proceed to add clean water into the water tank. While adding the water, make sure that you keep an
eye on the water level indicator to make sure that you do not OVER or UNDER FILL the unit. Press the
button Cool after you have added the water and the unit should commence to blow cooler air. The cool light
will light on at the same time. When you press the button Cool again, it will stop working, the cool light will
also go out.
8-2 If you find that the air after Step 1) is still not cool enough, you can add additional ice block into the water
tank directly by opening the water tank cover. Be sure not to exceed the icebox capacity otherwise damage
to the unit or electric shock may occur.
8-3 If you wish to use an Ice box instead of ice block, just place it directly into the tank by opening the water
door. It will be good cooling efficiency if you place it in your refrigerator and let the ice pack freeze for 1 to 2
hours.
8-4 You may complete pull out water tank, then replace water in the water tank or clean water tank,
8-5 Under the cooling work condition, the appliance will delay 5 minutes to stop working when you shut off
the unit or timing finished, during the extended period, the timer pilot lamp is flashed.
9. ION button
To gain fresh air in your room, just press ION button and the build-in ionizer will operate.
10.SAVEENERGY button
Press the "SAVEENERGY " button once TO shut or open all indicators.
11.The function of above item can be carried out with your remote control by pressing the corresponding
function button. The remote control can work with a distance of within 5 meters and an angle about 20
degrees.