Axis Q60-S Serie Montageanleitung Seite 23

Install an SD Card
It is optional to install an SD card (not included), which can be used for local recording with
removable storage.
1. Loosen the dome ring screws and remove the dome cover.
2. Insert an SD card (not included) into the SD card slot.
3. Attach the dome cover to the top cover and tighten the screws (torque 3.2 Nm).
NO TICE NO NO TICE TICE
To prevent corruption of recordings, the SD card should be unmounted before it is ejected.
To unmount, go to Setup > System Options > Storage > SD Card and click Unmount.
Pressurize the Camera (Recommended)
The camera housing can be filled with Nitrogen gas to prevent condensation.
The filling process is repeated three times, releasing the pressure between fillings, to make sure that
all air and humidity is purged from the housing.
Note
The camera housing has an pressure relief valve that limits the filling pressure to 0.5 bar
(7 psi). During normal use the pressure inside the camera housing may drop below that
pressure. For full protection make sure that the pressure is above 0.2 bar (3 psi) .
1. Set the regulator gauge on the gas cylinder to 0.5 bar (7 psi).
2. Remove the caps from the inlet valve and the pressure relief valve.
3. Place the chuck on the inlet valve and press down to fill the camera with nitrogen.
4. When the pressure inside the camera housing reaches 0.5 bar (7 psi) the pressure relief
valve will open. Place your hand over the pressure relief valve to verify that the gas
is flowing out.
5. Keep the gas flowing through the camera housing for one minute before removing the
chuck from the inlet valve.
6. Lift the pressure relief valve to let the overpressure out of the camera unit.
7. Repeat the filling process a total of 3 times, leaving the the camera pressurized the
last time.
8. Put the caps back on the inlet valve and the pressure relief valve.
Install the Power Supply and the Media Converter Switch
The supplied media converter switch enables the multi-connector cable to send power from the
power supply (sold separately) and to send and receive data to and from external alarm devices
and the network.
AXIS Q60-S Series
23