Greencut GSC1700C Betriebsanleitung Seite 52

52
REMOVING OR REPLACING THE SPIKED ROLLER
To remove the roller:
1. Unscrew the screw (S) and remove it from the bearing cover.
2. Lift the bearing cover (B) and remove the roller from the machine rake.
3. Remove the roller cover from the rake.
To replace the roller:
1. Place the rake roller cover.
2. Place the rake roller in the housing.
3. Fasten two screws.
1
CLEANING GUIDE
ATTENTION: Do not use solvents, chemicals or abrasives when cleaning the machine as this may
damage some surfaces.
• Use gloves or appropriate tools for cleaning. Do not do it with unprotected hands.
• Clean the machine after each use to ensure best performance and durability.
• Use a slightly damp cloth, water and a mild detergent for cleaning.
• Use a brush for parts or pieces that are difficult to access.
• Ensure that all vents designed for heat dispersion are clean and free from obstructions or debris.
• Remove grass clippings, dirt, etc. from the underside of the cover and blades.
• Make sure all hoppers and covers are clean and unobstructed.
• Make sure that the spring terminals, such as the rear cover, return to their places when they are released.
• Clean and check the collection basket for damage and replace damaged parts as required. Allow the collection
basket to dry completely before storing to prevent deterioration or rotting.
• Make sure all cables, levers, switches, etc. are clean and working as they should and without problems.
S
2
B
3