Cleaning And Maintenance - Bestron ABP603 Bedienungsanleitung

oPerAtIon - Preheating
1. Put the appliance on a level and heat-resistant surface.
Only the supplied cable with thermostat may be used.
3. Put the plug in the wall socket.
4. Adjust the thermostat dial to the required temperature
(position 1 through 5). The indicator light on the thermostat
will illuminate to show that the heating element has been
switched on.
Position Temperature (°C)
1 approx. 170°C
2 approx. 190°C
3 approx. 210°C
4 approx. 220°C
5 approx. 230°C
5. After waiting a few minutes check whether the indicator light is extinguished. Once the indicator light has
extinguished the appliance has reached the required temperature, and is ready for use.
During use the heating element will switch on and off to keep the temperature of the grill plate constant.
Consequently the indicator light will also occasionally be illuminated.
oPerAtIon - Grilling
1. Allow the grill plate to preheat (see 'Preheating').
2. If so required, grease the grill plate with a little oil.
3. Place the food you wish to grill on the grill plate.
4. Grill the food until it is cooked. Turn the food over occasionally whilst it is being grilled to ensure that both
sides are evenly cooked.
5. Remove the food from the grill plate and place on a plate. Take care! The food is hot.
Do not use a fork, knife or other sharp object! You can damage the non stick coat with it. THERE WILL
BE NO GUARANTEE WHEN DAMAGING THE BAKING PLATE BY SHARP OBJECTS!
oPerAtIon - After use
1. Turn the thermostat dial to the "0" position.
2. Remove the plug from the wall socket.
3. Let the appliance cool down fully.
4. Remove the thermostat by holding the appliance's handle
with one hand and pulling the thermostat out of the socket
with the other hand. Make sure you do not touch the
appliance's metal socket; it may still be hot. Always hold
the thermostat by the plastic section
The metal pin fitted to the thermostat can be very hot.

cLeAnInG And MAIntenAnce

Clean the grill plate after each use.
1. Remove the plug from the wall socket, allow the appliance to cool down completely, and pull the
thermostat out of the socket.
2. Clean the grill plate and the base with a damp cloth, if necessary moistened with a couple of drops of
washing-up liquid.
3. Dry the grill plate and the base thoroughly.
• Verify that the appliance is not connected to the power supply before you start to clean it.
• Never use corrosive or scouring cleaning agents or sharp objects (such as knives or hard brushes)
to clean the appliance.
• Never immerse the socket, thermostat, plug or power cord in water or other liquid.
5
5
20
Instruction manual