Use - Casselin CCAEF Bedienungsanleitung

WARNING
By operating the apparatus may reach high temperatures. To avoid burns and accidents, do not use
the machine malfunction and do not use spare parts that do not origins.
ELECTRICAL HAZARD
Risk from electrical current!
In case of improper installation, the device can be dangerous and cause injury. Before installation, check the
power system data. Connect the device only when there is compliance. The unit should be unpacked and
checked fully before connecting by a professional.

5.2 Use

WARNING
The establishment of the installation of the device and maintenance must be performed only by professionals.
• Do not leave the unit without monitor.
• During use, your hands should be dry.
• Do not move or tilt the device during operation.
MANUAL
INSTALLATION
Remove the packaging egg cooker and place the device on a flat and smooth surface. detach
plastic coating of the device.
If this unit is placed near a wall, a partition, a kitchen cabinet, a decoration, etc.,
they must be coated with a suitable non-inflammable coating or a thermal insulating material
fuel and power be given to fire prevention regulations.
Once the egg cooker was developed in consultation with international standards and regulations.
The egg cooker is ready for operation.
SURGERY
Filling the water tank up to the mark. Use clean water to use.
Connect the device and turn it on, turn the temperature control in the direction of clockwise
to the desired setting, the element begins to heat and the green light is on. A parameter
Operation is in the 5 position (about 65-80 degrees). When not in use, simply
simply turn the temperature knob, turn off and unplug the unit.
SECURITY
Do not overfill the water to water tray, the unit has been installed with a thermal cutout to avoid
overheating or material damage.
If the power cord is damaged, it must be replaced by a qualified technician.
NOTE
The device has a security system in case of overheating. Upon activation, disconnect the device and allow it
to cool. If this protection system will start regularly, it is imperative to contact your dealer.
After automatic shutdown, the unit may be commissioned only by pressing the reset button on the unit's back
for this, wait until the temperature drops, press the Reset button.
EN