14 Cleaning
Before cleaning always switch off the appliance. Pull out the mains plug or switch off or
unscrew the fuse.
•
Clean the inside and outer walls with lukewarm water and a little detergent. Do not use
abrasive or acid cleaners or chemical solvents.
•
Use a glass cleaner to clean the glass surfaces and a commercially available stainless-steel
cleaning agent for the stainless-steel surfaces.
•
Ensure that no cleaning water penetrates into the electrical components or ventilation grille.
•
Do not damage or remove the type plate on the backside of the appliance. It is very important
for servicing purposes.
15 Malfunctions
• E1, E2, E3, E4, E5, E6, 00, HH or LL appears in the display.
à
The appliance has suffered a fault. Contact the customer service department.
You may be able to rectify the following faults by checking the possible causes yourself.
• Appliance does not function.
à
Is the appliance switched on?
à
Is the plug correctly fitted in the mains socket?
à
Is the fuse intact?
• When inserting the mains plug, the refrigeration unit does not switch on, but a value is
shown in the temperature display.
à
Demo mode is activated. Please contact the customer service department.
• Loud running noise.
à
Is the appliance set up firmly on the floor?
à
Does the appliance cause nearby items of furniture or objects to vibrate?
Please note that noises caused by the refrigerant circuit cannot be avoided.
• The temperature is not low enough.
à
Is the temperature setting correct (see "Setting the temperature")?
à
Does the separately installed thermometer show the correct reading?
à
Is the ventilation system working properly?
à
Is the appliance set up too close to a heat source?
Do not use steam cleaners because of the
risk of injury and damage.
19