Werbung
Verfügbare Sprachen
Verfügbare Sprachen
4 Range of appliance use
The appliance is suitable solely for storing wine and cigars (CLB series) in a domestic environment
or similar.
This includes, for example, use
•
in staff kitchenettes, bed and breakfast establishments,
•
by guests in cottages, hotels, motels and other forms of accommodation,
•
in catering and similar services in the wholesale trade.
Use the appliance solely as is customary within a domestic environment. All other types of use are
inadmissible. The appliance is not suitable for storing and cooling medicines, blood plasma, laboratory
preparations or similar substances and products covered by the 2007/47/EC Medical Devices Directive.
Any misuse of the appliance may result in damage to or spoilage of stored goods. Furthermore, the
appliance is not suitable for operation in potentially explosive atmospheres.
5 Before Commissioning
1. Transportation of cooling cabinet
ATTENTION:
•
SWISSCAVE devices cannot be laid down.
•
The devices are to be carried diagonally. That means that the person carrying the underside
carries the device on its front grid (below the doors) and that when negotiating stairs this
person always stands the lower.
•
If the device has to be temporarily set down then this it should be stood straight up, and not
placed on its side.
2. Avoid positioning the appliance in direct sunlight or near cookers, radiators and similar sources
of heat.
3. Place the device on a firm, dry and plain-level surface. The cabinet should not be exposed to
temperatures below freezing point, nor to vibrations, pushes or wet environment.
4. Standard EN 378 specifies that the room in which you install your appliance must have a
volume of 1 m3 per 8 g of R 600a refrigerant used in the appliance, so as to avoid the
formation of inflammable gas/air mixtures in the room where the appliance is located in the
event of a leak in the refrigerant circuit. The quantity of refrigerant used in your appliance is
indicated on the type plate on the inside of the appliance.
5. Always install the appliance directly against the wall.
6. With the front leveling screws the cabinet can be plain-leveled so that it stands completely
straight, even if there is any unevenness in the floor.
7. After definitive placement of the cooling cabinet it should not be connected to power for the
duration of at least 12 hours. The compressor may be damaged if this instruction isn't followed.
15
Werbung
