Working Instructions; Cleaning And Maintenance; Cleaning And General Maintenance Work - Grizzly BRM 46-160 HA Originalbetriebsanleitung

wards the handle bar. The
mower moves forwards.
Off: Release the drive catch (2)
The equipment stops.
Set petrol lever (23) to position
for short breaks and to redu-
ce noise
The change in motor revolutions
via both positions
does not influence the speed of
the power wheels. They cannot be
regulated.

Working Instructions

• As far as possible, mow the lawn
when it is dry in order to protect the
turf.
• Set the cutting height such that the
equipment is not overloaded.
• Run the equipment at walking speed
in lines that are as straight as pos-
sible. For uninterrupted mowing, the
lines should always overlap by a few
centimetres.
• Do not move backwards.
• On slopes, always work across the
slope.
• If the blade comes into contact with
a foreign body, switch off the engine
immediately. Wait until the blade is
stationary and check the equipment
for damage. Restart work only if the
equipment is undamaged.
• Switch off the equipment during long-
er breaks and for transportation and
wait until the blade is stationary.
• Clean the equipment after each use,
as described in the "cleaning and
maintenance" chapter.

Cleaning and Maintenance

+
Cleaning and General Mainte-
nance Work
• Always keep the equipment clean. To
clean, use a toothbrush or cloth but no
corrosive cleaning agents or solvents.
Do not use water to clean the engine
as it could contaminate the fuel sys-
tem.
• After mowing, remove plant remains
that are stuck to the equipment by
using a piece of wood or plastic. Cle-
an the vent holes, ejection hole and
blade area especially. Do not use hard
or pointed objects, which could dama-
Have any repair and mainte-
nance work not described in
these instructions carried out by
a specialist workshop. Use only
original Grizzly replacement
parts. Risk of accidents!
Carry out maintenance and clean-
ing work strictly with the engine
switched off and spark plug con-
nectors removed. Risk of injury!
Allow the equipment to cool
before any maintenance and
cleaning work. Elements of the
engine are hot. Risk of burning!
Wear gloves when handling the
blade.
We recommend contacting an
authorised Honda dealer for main-
tenance work on the engine.
Do not tilt the equipment sideways
or forwards. Operating fluids could
leak out and the engine could be
damaged.
UK
87