Getting Started; Setup - Barracuda NextGen Firewall X Serie Kurzanleitung

1

Getting Started

Barracuda recommends reading these instructions fully before starting
to install. To install and configure you need the following:
• Barracuda NextGen Firewall X-Series, AC Power Cord (included)
• Power supply (X100/X101/X200/X201 only)
• Wi-Fi antenna (X101/X201 only)
• Mounting brackets (X300 and above)
• Ethernet Cable
2
Connect
• Connect port P1 to your PC.
• Connect port P2 to your ISP.
• Change the network settings on your PC to:
IP Address: 192.168.200.100
Netmask: 255.255.255.0
Gateway: 192.168.200.200
• Power on the Barracuda NextGen Firewall X-Series and wait two minutes until
fully booted.
Barracuda NextGen Firewall X
Management PC
Alert: The Barracuda NextGen Firewall X-Series must be assigned an IP address by a DHCP
server of your ISP.
4

Setup

P1 P2 ISP
Internet