Werbung
Verfügbare Sprachen
Verfügbare Sprachen
USING YOUR TEA MACHINE
• When you take the teapot to fill tea pull and take off its base from
the settled surface. Thus, the drops that accumulate on the base will be
poured in the water heater.
• Wash inside your Arzum Tea Machine by means of putting water in
it before the first use. Boil it for two or three
times in the water heater and change the
water every time. Ensure that the water is
at the maximum level when you perform
this process. Discharge the hot water before
every boiling and wash inside your appliance
with cold water.
• Fill in your water heater water always
between the levels min (0.5 lt) or max (1.8 lt).
If you attempt
boiling the water
under the minimum
level, it will cause
your appliance to
be shut off earlier
and if you attempt
the water above
the maximum level,
it will cause water
to overflow.
• Open the teapot lid and remove the tea filter and add sufficient amount
of tea in the filter and add some cold water and then replace it on the
teapot.
• Open by taking the main switch to (I) and the boiling switch to (
)
position. The red pilot light will be on and the water will start heating.
• Depending on the amount of water added, the water will start boiling
within 3-8 minutes and the boiling switch will pass automatically to the
14
ARZUM
Werbung
