AA-Drill 77345/1 Betriebsanleitung Seite 21

Drill chuck and arbor:
Slide small end of arbor into the chuck, place long end inside spindle, hold crank
table 5 inches from tip of spindle, open chuck completely, pull feed pinion down,
pressing the chuck against the table till arbor is secure.
Morse taper drill bits:
To use Morse taper bits, remove chuck and taper. To remove
taper and chuck, adjust stationary depth to 3 inches (see
depth instructions). Turn spindle manually lining up spindle
and quill key holes. Using key bar tap lightly until taper and
chuck fall out. Loosen half wing bolt and allow spindle
assembly to return to its original position.
Place tapered bit into the spindle hole, twisting and pushing
upward until bit is snug. Place a block of wood on the table and crank up table until
the tapered bit is firmly into the spindle.
Changing speeds:
Choose the proper speed for the drilling operation and the
type cutter or drill bit being used.
1. With the tool running unlock the speed control handle
(1) on the left of the drill press head assembly.
2. Move the lever to the front to decrease the speed and
rear to increase the speed.
3. When the indicator on the control handle (1) is in line
with the desired speed on the speed scale, lock the
speed control knob clockwise until tight.
Warning: the speed control handle should always be locked.
19