Hyundai KVE 893 Bedienungsanleitung Seite 19

TO OPERATE SCALE
1) Please put the scale on a hard and flat surface.
2) Place bowl (if used) on the scale before turning on the UNIT.
3) Press the button ON/OFF to turn on the scale.
4) When the display shows 0, the appliance is ready for weighing.
5) Put the food (thing) you want to weigh in the centre of the measuring glass tray (P2)
and wait for settling the value shown on the display.
6) After weighing, you may turn off the scale by pressing the ON/OFF button or the scale
will turn off automatically after 130 seconds.
TO CONVERT WEIGHT MODE
The scale may indicate weight in the following units (g – grams, lb – pound and oz –
ounce), volume can be displayed in the „ml – milliliter" unit for water and milk.
Repeatedly press the UNIT button to change the units as follows: 0 g / 0 lb / 0 oz / 0 ml
(water) / 0 ml (milk).
„ZERO" OR „TARE" FUNCTION
To weigh different loads consecutively without removing loads from the scale. Put first Load
on the scale, get weight reading. Press (P3) button to reset the LCD reading to „0" before
adding next load. Add another item and the display will read the added weight. You can
repeat this operation. If all products are taken away from the weighing plate,a negative
value will appear on the display.
Note 1: „ZERO" function
When total sum of all loads on scale ≤ 2 % of scale´s max weight capacity (100 g when
capacity is 5 kg). LCD will show „0" each time (P3) is pressed. Max. weight capacity
remains unchanged.
Note 2: „TARE" function
When total sum of all loads on scale > 2 % of scale´s max weight capacity (100 g when
capacity is 5 kg). LCD will show „0" each time (P3) is pressed. LCD will show icon „TARE",
indicating „TARE" function is active. Max. weight capacity is reduced by total weight of all
loads.
HOW TO WEIGHT WATER/MILK
Please press UNIT to change the unit to water/milk (ml). When you put the bowl onto the
scale, its weight will be shown on the display. Please press (P3) to clear the weight of the
bowl. The display will show „0" ml. Then put the water/ milk into the bowl and the display
will show the volume of the water/milk.
– You may put the container for liquids on the scales before turning it on. If you do so,
the scale will turn on automatically when reaching 0.
– The results of measuring the volume of milk differ from measuring the volume of water
due to their density. Milk has subtly higher density than water (approx. 1. 028 x).
AUTO SHUT OFF
Auto shut-off occurs if display shows ‚0' or shows the same weight reading for 130 sec.
Note
19 / 31
ENG