Alde AquaClear 3030033 Einbauanleitung Seite 14

Installation instructions Alde AquaClear
Intelligent water purification
WARNING
UV-C is dangerous for eyes and skin. Never look into a powered unit.
CAUTION
The Alde AquaClear UV-C unit signal cable may only be connected to the Alde Compact 3030 or
to the Alde LED panel. (Electrical and signal connection to Alde Compact 3010/3020 can damage
the unit.)
NOTICE
Ordinary handling of an electrical product. The product works in plus degrees and up to about 50 ° C
air temperature, about 40 ° C water temperature. The product is intended for a water pressure of 2
bar and can withstand peaks up to 5 bar.
Alde AquaClear UV-C is a robust and compact water purification product for increased safety of
water quality in low pressure applications where water is replenished externally and stored in a tank,
and where the risk of microbiological growth is thus higher.
The disinfection is based on UVC light, through the latest UVC LED technology, and the product
neutralizes about 99% of microorganisms at water flows (up to 4 liters/min).
The pressure drop over AquClear is up to 0,9 bar, so a fresh water pump with a pressure of at least 2
bar is recommended.
Note!
The first time you flush the tap after replacing the Alde Water Carbon filter, black carbon dust may be
present in the first liter.
CAUTION
Water-filled unit must not be exposed to sub-zero temperatures. If there is a risk of temperatures
below 0 ° C, the unit must be drained. The product contains a glass in front of the UVC source and
the glass risks cracking if the water in the unit freezes!
NOTICE
Before cleaning the water system, remove the Alde Water Carbon filter to prevent the cleaning
particles from getting stuck in the filter.
14