Icy Box IB-DK2108M-C Handbuch Seite 12

Manual IB-DK2108M-C
6. Reattach the cover and the two screws previously removed.
7. Ready to use!
8. Optionally, you can use the supplied protective rubber sleeve to protect the unit.
To do this, place the device in the sleeve according to the cut-outs for the connections.
Advice for an installed M.2 NVMe drive (optional)
M.2 NVMe SSD not inluded
The IB-DK2108M-C with installed M.2 NVMe drive inside can be connected to or
disconnected from the computer via USB cable without shutting down the computer.
A new drive must first be initialized, partitioned and formatted by the operating
system in order to be displayed by the system.
If the drive is not recognized instantly by the operating, system please check:
- if the driver software is installed (USB)
- if the SSD is initialized, partitioned and formatted
Please await the end of read/write operations before disconnecting the drive in
order to avoid data loss.
The full USB 3.1 (Gen 2) transfer rate can only be achieved with a USB 3.1
(Gen 2) host computer. Furthermore, the USB 3.1 (Gen 2) drivers must be installed
by the operating system. If this is not the case, install the appropriate drivers for your
operating system (Windows , macOS ).
® ®