Safety Advices - KPS TP5000HY Benutzerhandbuch

TP5000HY
• Resistor
Range Resolution
Output Voltage : about 0.5V
Overload Protection : AC/DC 1000V
• Continuity
Continuity : The built-in buzzer sounds in the case of measuring resistance less
Continuity Indicator :
Response Time of Buzzer : < 100 msec.
Output Voltage : about 0.5V
Overload Protection : AC/DC 1000V
• AC Ampere
Range Resolution
200.0A 0.1A
Frequency Response :
Overload Protection : AC/DC 200A
• Rotary Field Indication
For 3 phase 4 wire system only
Sensitivity : 90V to 1000V (Phase-to-ground)
Frequency Range :
the signal L2 probe.
• Single-Pole Phase Check
Sensitivity : 90V to 1000V (Phase-to-ground)
Frequency Range :
Indicator :

SAFETY ADVICES

Depending on the internal impedance of this meter there will be a
different capability of indicating the presence or absence of operating
voltage in case of the presence of interference voltage.
When in contact with the parts to be tested, this meter may discharge
temporarily the interference voltage to a level below the ELV, but it will
be back to the original value when this meter is removed.
recommended installing earthing equipment before work.
expected to be disconnected of the installation, it is highly
recommended confirming by another means (e.g. use of an adequate
voltage detector, visual check of the disconnecting point of the electric
circuit, etc.) that there is no operating voltage on the part to be tested
and to conclude that the
voltage indicated by this meter is an interference voltage.
Accuracy
±(1.5% + 5D)
Accuracy
±(3.0% + 5D)
08
EN