Husqvarna 320W Mono Installationsanleitung Seite 6

Unit should be installed so that the solar panel is positioned towards the
Earth's equator. Consult your dealer for the best panel angle based on
your latitude.
Gloves & Safety glasses should be worn during installation.
Recommended Tools (Not provided)
Small Knife
The above tools and equipment are highly recommended to have available to assist with
installation.
Installation diagram
All Cap Head Bolts must have a lock washer and flat washer before
feeding through a hole. A flat washer will also need to be placed behind
the hole before the nut.
Please check the installation drawing carefully. The red part of the drawing
shows the length of the each bracket and their fixing holes. Next to each
fastened hole is a number that represents the screw to be fastened The angle
of the solar panel can be adjusted using the alternate holes in the L-Bracket
Column (Part-D) & L-Bracket Bottom (Part-C)
Installation
Cable tie
M8 Drill Bit
13mm Nut Wrench Cross-head Screwdriver