ARGENTO Active Bike Benutzerhandbuch Seite 24

Adjusting the brake callipers
Active Bike
If the brake is too tight or too loose, use the Allen key to loosen bolt (C), then adjust the brake cable,
(shorten the brake cable upwards if it is too tight, if it is too loose, pull the brake cable downwards)
and then, retighten bolt (C). If it is too loose or too tight, even after following the first step, adjust the
brake pad (fixed) using the Allen key to move the pad (D) away / closer together.
Active Sport
If the brake is too tight or too loose, use the Allen
wrench to loosen the screw (A), then adjust the
brake cable, (shorten the brake cable at the top if
it is too tight; if it is too loose, pull the brake cable
downwards) and then, retighten the screw (A).
Check the correct alignment between the brake
caliper and the disc. Use the screws (B) and (C)
to adjust the position / alignment on the disc, if
necessary.
Argento by Pininfarina KPF
If the brake is too tight or too loose, adjust it
by loosening or tightening the screw (A).
If the brake lever is too soft or too hard even
after following the instructions in the first step,
it may be necessary to repeat the operation
until the optimal setting has been reached.
23