Installing The Switch - Edimax ES-5844P Schnellinstallationsanleitung

Installing the Switch

3.
With the Plug-and-Play design, the Fast switch is easy to install and use.
The network and port status can be easily monitored and also
trouble-shooting van be done via diagnostic LEDs. Wiring auto crossover
on all ports of the switch also allows the connection to the server or PC to
free from cabling problems.
In the switch, TP port supports MDI/MDI-X auto-crossover, so both
•
types of cable, straight-through (Cable pin-outs for RJ-45 jack 1, 2, 3,
6 to 1, 2, 3, 6 in 10/100M TP) and crossed-over (Cable pin-outs for
RJ-45 jack 1, 2, 3, 6 to 3, 6, 1, 2) can be used.
• Use Cat. 5 grade RJ-45 TP cable to connect to a TP port of the switch
and the other end is connected to a network-aware device such as a
workstation or a server.
Repeat the above steps, as needed, for each RJ-45 port to be
•
connected to a Fast 10/100 TP device.
For Fast Ethernet TP network connection
•
⎯ The grade of the cable must be Cat. 5 or Cat. 5e with a maximum
length of 100 meters.
Insert the power cord. The embedded internal power unit using
•
different AC power cord is available for different areas.
PSE TP Switch with Powered Device (PD)
• Connect the PSE switch to an AC power source.
• Install the TP media cable to the IEEE 802.3af PD for port 1 to 4.
Note: The switch can work as a pure switch that connects to non-PoE
devices.
• Install the media cable for network connection.
Port 5 to 8 are pure TP ports for non-PoE devices.
•
3
All manuals and user guides at all-guides.com