DeLOCK 90518 Bedienungsanleitung Seite 3

English
Connecting the scanner to the system
To connect the scanner to the system, please connect the cable to the computer
(USB-A socket), push scanner button and the code below. After successful con-
nection you will hear two beeps.
Match
If your scanner does not output any values after scanning, please check the
connection to the computer, - as well as the battery level.
If the battery is very low, the scanner cannot read any scans. -
And then connect the scanner to the computer. After a successful connection you
will hear two beeps.
Reset scanner to factory settings
To reset the scanner to its factory settings, please scan the codes below in
sequence. After the second code the scanner switches off, please wake up by
button push and go forward. After a successful connection, the scanner should
emit two beeps. Afterwards please choose your language (page 5).
Important: After the scans, give the scanner a little time (1-2 seconds) to
process the codes internally.
1. Reset
2. Wireless restore
should turn off -wake up by pushing scanner button
3. Match
-3-